Julia Steiner

Julia Steiner

Auto-generated profile, based on publicly available information

Julia Steiner

Department of Wind and Energy Systems, Technical University of Denmark, Frederiksborgvej 399, 4000 Roskilde, Denmark

Research Focus & Metrics

Academic Career Length

36Years (1991-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 May 1991 in Monthly Weather Review
Verified
Journal Article
Open access
RSR. K. Smith
R. K. Smith
RRR. N. Ridley
R. N. Ridley
MPM. A. Page
M. A. Page
JSJ. T. Steiner
J. T. Steiner
ASA. P. Sturman
A. P. Sturman
A combined observational and climatological study of orographically influenced cold fronts over New Zealand, known locally as “southerly changes,” is presented. Four southerly changes that occurred along the east coast of New Zealand during the Southerly Change Experiment (SOUCHEX) in January and February of 1988 are analysed in detail using the higher spatial and temporal density of data established for the experimental period. Three of the southerly changes were associated with fronts originating over the Tasman Sea, while the other was not. A common feature in all four cases was the shallowness of the southerly flow for sonic hours after the surface wind change. The top of the southerly flow layer was less than the typical height of the Southern Alps (2000). Above this there was usually a maximum of the northerly component of the flow at or just above mountain- top levels and in three casts the prefrontal low-level flow was dominated by a warm northwesterly foehn. In the central South Island t... Abstract A combined observational and climatological study of orographically influenced cold fronts over New Zealand, known locally as “southerly changes,” is presented. Four southerly changes that occurred along the east coast of New Zealand during the Southerly Change Experiment (SOUCHEX) in January and February of 1988 are analysed in detail using the higher spatial and temporal density of data established for the experimental period. Three of the southerly changes were associated with fronts originating over the Tasman Sea, while the other was not. A common feature in all four cases was the shallowness of the southerly flow for sonic hours after the surface wind change. The top of the southerly flow layer was less than the typical height of the Southern Alps (2000). Above this there was usually a maximum of the northerly component of the flow at or just above mountain- top levels and in three casts the prefrontal low-level flow was dominated by a warm northwesterly foehn. In the central South Island t...

14 March 2022 in Wind Energy Science
Verified
Journal Article
Open access
PDF file
AVAxelle Viré
Axelle Viré
BLBruce LeBlanc
Bruce LeBlanc
JSJulia Steiner
Julia Steiner
NTNando Timmer
Nando Timmer
There is continuous effort to try and improve the aerodynamic performance of wind turbine blades. This experimental study focusses on the addition of a passive slat on a thick airfoil typically used in the inboard part of commercial wind turbine blades. Nine different slat configurations are considered, with both a clean and tripped main airfoil. The results are compared with the performance of the airfoil without slat, as well as the airfoil equipped with vortex generators. It is found that, when the airfoil is clean, the increase in lift-to-drag ratio due to the presence of a slat is larger than when vortex generators are used. This is also true for the tripped airfoil but only at small angles of attack. As expected, in all configurations, the presence of the slat delays flow separation and stall. Finally, for a clean airfoil and small angles of attack, the slat decreases the lift-to-drag ratio of the main airfoil only. By contrast, as the angle of attack increases, it seems that the slat changes the flow field around the main airfoil in such a way that its lift-to-drag ratio becomes larger than for the airfoil without slat. These effects are less pronounced when the airfoil is tripped. This work helps to better understand the role of a slat in improving the aerodynamics of blade sections. It can also be used to validate simulation tools in the field.

11 May 2026 in Wind Energy Science
Verified
Journal Article
Open access
PDF file
JSJulia Steiner
Julia Steiner
EHEmily Louise Hodgson
Emily Louise Hodgson
PLPaul Van der Laan
Paul Van der Laan
LALeonardo Alcayaga
Leonardo Alcayaga
MPMads Mølgaard Pedersen
Mads Mølgaard Pedersen
PRPierre-Elouan Réthoré
Pierre-Elouan Réthoré
Wake steering is a promising control strategy for wind farm optimization, yet its effectiveness depends on the accuracy of underlying aerodynamic and structural models. In this study, we evaluate the predictive capabilities of models with varying fidelity for the IEA 22 MW reference turbine, considering both a single turbine and a two-turbine row with 5D spacing under conventionally neutral atmospheric boundary layer conditions. Results are benchmarked against large-eddy simulations (LESs). All models reproduced qualitative trends in power and, where applicable, loads as a function of yaw angle and downstream position, but there was a large spread in quantitative agreement. The dynamic wake meandering (DWM) model implemented in Dynamiks gave very good predictions for mean power, acceptable results for blade and yaw bending damage equivalent loads (DELs) but heavily underpredicted the tower bottom DELs compared to LESs. RANS results from EllipSys3D resolved asymmetric wake features but with reduced magnitude, leading to increasing errors for power prediction with increasing wake deflection. Steady-state engineering models (PyWake and Fuga) performed reasonably well for power prediction in the aligned cases but showed increasing errors under yaw misalignment. None of the engineering models reproduced secondary steering. These findings highlight the limitations of the tested engineering and mid-fidelity models, and emphasize the need for improved treatment of wake asymmetry, veer effects, and meandering physics to enhance reliability in practical optimization applications.

20 October 2025 in EGUsphere
Verified
Preprint
Open access
PDF file
JSJulia Steiner
Julia Steiner
EHEmily Louise Hodgson
Emily Louise Hodgson
PLPaul Van der Laan
Paul Van der Laan
LALeonardo Alcayaga
Leonardo Alcayaga
MPMads Mølgaard Pedersen
Mads Mølgaard Pedersen
PRPierre-Elouan Réthoré
Pierre-Elouan Réthoré
Wake steering is a promising control strategy for wind farm optimization, yet its effectiveness depends on the accuracy of underlying aerodynamic and structural models. In this study, we evaluate the predictive capabilities of models with varying fidelity for the IEA 22 MW reference turbine, considering both a single turbine and a two-turbine row with 5D spacing under conventionally neutral atmospheric boundary layer conditions. Results are benchmarked against large-eddy simulations (LES). All models reproduced qualitative trends in power and, where applicable, loads as a function of yaw angle and downstream position, but there was a large spread in quantitative agreement. The dynamic wake meandering (DWM) model implemented in Dynamiks gave very good predictions for mean power, acceptable results for blade and yaw bending Damage Equivalent Loads (DELs), but heavily underpredicted the tower bottom DELs compared to LES. RANS results from EllipSys3D resolved asymmetric wake features, but with reduced magnitude, leading to increasing errors for power prediction with increasing wake deflection. Steady-state engineering models (PyWake and Fuga) performed reasonably well for power prediction in the aligned cases but showed increasing errors under yaw misalignment. None of the engineering models reproduced secondary steering. These findings highlight the limitations of the tested engineering and mid-fidelity models and emphasize the need for improved treatment of wake asymmetry, veer effects, and meandering physics to enhance reliability in practical optimization applications.

1 May 2026 in Journal of Physics: Conference Series
Verified
Conference Paper
Open access
JSJulia Steiner
Julia Steiner
EHEmily Louise Hodgson
Emily Louise Hodgson
AFAlexander Meyer Forsting
Alexander Meyer Forsting
PRPierre-Elouan Réthoré
Pierre-Elouan Réthoré
Accurate wake superposition is essential for time-domain wind-farm models operating in deep-wake conditions, such as aligned turbine rows. Conventional linear and root-sum-square superposition methods often fail to predict realistic power recovery and wake deficits in such configurations. This paper investigates the application of a momentum-conserving wake superposition (MCS) method within the Dynamic Wake Meandering (DWM) framework for statistically stationary inflow. The MCS approach is implemented using a steady-state mean-flow estimate to determine superposition weights and is compared against linear and root-sum-of-squares (RSS) methods. Simulations are performed for aligned rows of IEA 22 MW turbines using both a parabolic RANS-based Ainslie wake model and an analytical Gaussian deficit model, and are validated against large-eddy simulation results. The results show that while the MCS method enforces convergence toward an equilibrium power level in deep turbine rows and provides power predictions between the linear and RSS methods, it takes much longer to reach equilibrium power production along the row than in the LES reference data. Hence, the tested MCS method does not consistently outperform the other simpler superposition approaches. However, since the DWM results underpredict wake expansion and wake-added turbulence, it seems likely that better calibration of those properties would further improve the method’s utility.