Introduction: This article aims to discuss the physico-chemical features of the agglomeration process of phosphorus fines using phosphate-siliceous shales and oil sludge. Methods: The composition and structure of the starting materials and physico-chemical transformations under thermal influence are studied using IR spectrometry and differential thermal analysis methods. Results: The results of IR spectrometric analysis of the phosphate siliceous shales are characterized by intense peaks at 493.78, 547.78, and 678.94 cm-1, corresponding to Ca-O-P compounds. Moreover, the wave oscillations in the region of 837.11-995.27 cm-1 indicate the characteristics of Si-O valence bonds, and in the region of 1114.86-1431 cm-1 depict the characteristics of Si-O-Al compounds. The IR spectrum of oil sludge is characterized by the presence of wave oscillations in the region of 1411.89-2904.80 cm-1 corresponding to petroleum components. Conclusion: The differential thermal analysis of the investigated sample of phosphate-siliceous shale does not have intense endo- and exo-effects, and it is characterized by a significant predominance of hydrate compounds of aluminosilicate and carbonate components.
29 June 2024 in Bulletin of Shakarim University. Technical Sciences
The article presents the results of physico-chemical and thermodynamic studies of the use of petroleum coke obtained from oil refining waste for use in agglomeration of phosphate raw materials as fuel.Using the method of thin-layer chromatography and IR spectroscopy, groups of organic compounds in the composition of heavy waste used for slow coking of petroleum coke were determined. The obtained results of the analysis of heavy oil waste showed a high content of strong aromatic groups 35.1-54.1%, resin groups 12.0-25.7%, paraffin groups 3.0-41.4%. All these indicators indicate the suitability of heavy oil waste for the production of petroleum coke.The element composition and microstructure of the resulting petroleum coke, which contains C-78.56%, Te-4.05%, Al-12.14%, Si-1.18%, were identified using a scanning electron microscope JSM-6490LV.The results of thermodynamic studies of reactions characteristic of agglomeration firing of a working mixture of phosphorite-phosphate-siliceous shale - neftekox composition are presented, performed using the HSC-5.1 Chemistry software package developed by Outokumpu Research Oy. The results of calculating the Gibbs energy change from the temperature of decarbonization reactions indicate the thermodynamic probability of all studied reactions occurring in the high-temperature region. Moreover, the probability of 5.6 reactions is possible only above 1200K. Thermodynamic modeling of decarbonization of the working systems СаСОз – С – С6Н6 –О2 и СаСО3 – С – С6Н5О – О2 were performed in the temperature range 500-1500 K and pressures 0.1-0.01MPa, typical for the agglomeration process using the Astra-4 software package.The results of graphical dependences of the equilibrium distribution of the main components of calcium and carbon depending on temperature and pressure are of the same type. Moreover, as the pressure decreases, the possibility of formation of CaO and CO2 per 100 K moves to a low-temperature region.
19 September 2024 in The Open Chemical Engineering Journal
Introduction: The article presents the results of chemical and physicochemical analysis of initial lithium-containing hydromineral raw materials and sorbent based on bentonite clay with titanium oxide addition. Methods: It is established that the mineral is montmorillonite group and kaolinite according to the results of the analysis of the microstructure and elemental composition of bentonitic clay of the Darbazinsky deposit. Brine is characterized by the change of lithium chloride content in the range of 403-1001 mg/l. Physical and mechanical characteristics of the obtained sorbents based on bentonite clay and titanium oxide additive are characterized by a high mechanical strength of 5.31 MPa, density of up to 2,6 g/cm3, and specific surface area of 1572 cm2/g. The technological parameters of sorption extraction of lithium chloride from lithium-containing hydromineral raw materials were optimized using the system analysis “STATISTICA” developed by StatSoft company. It is established that to increase the rate of lithium chloride extraction from brine, it is necessary to maintain the rate of brine flow within 8 l/min at maximum humidity of solution output up to 43g/m3 on the basis of the obtained volumetric graphical dependencies. Results: The microstructure of the used sorbents with titanium oxide addition up to 20% is characterized by the predominance of lithium chlorides, which are represented by heap-shaped, prismatic crystals. Conclusion: The maximum amount of lithium chloride in the form of clusters of light-white crystals of tabular shape on the surface of the sorbent is observed at increasing the content of titanium oxide up to 40%.
For successful animal husbandry, farmers need to monitor the health status of animals on a daily basis, as well as ensure the safety and protection of animals. In this regard, the problem of choosing the optimal system for monitoring the condition of farm animals in the modern market is urgent. The practical value of the scientific article is to analyze the problems of stakeholders and, based on the needs, conduct a comparative analysis of various modern systems for monitoring the condition of small cattle using the weighted sum method. The object of the study was the process of monitoring the condition of small cattle using RFID tags, as well as the ability to monitor their health depending on the chosen approach. The subject of the study was a livestock enterprise that raises small cattle. It was found that the health of small cattle directly affects the financial stability of the farm. In the presented study, the authors analyze the problems of stakeholders and, based on the needs of stakeholders, conduct a comparative analysis of various modern systems for monitoring the condition of small cattle using the weighted sum method. The results obtained will help farmers make informed decisions in the future when choosing the most appropriate monitoring option for more effective and high-quality monitoring of the condition of small cattle, thereby reducing the risk of diseases and increasing profits for companies.