Minji Kim

Minji Kim

Auto-generated profile, based on publicly available information

Minji Kim

Department of Electrical and Computer Engineering/Inter-university Semiconductor Research Center, Seoul National University, Seoul, Republic of Korea

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 March 2024 in IEEE Journal of the Electron Devices Society
Verified
Journal Article
Open access
JPJunhyeong Park
Junhyeong Park
YYYumin Yun
Yumin Yun
MKMinji Kim
Minji Kim
SLSoo-Yeon Lee
Soo-Yeon Lee
In this paper, we conducted a simulation of an indium-gallium-zinc oxide (IGZO)-based neuromorphic system and proposed layer-by-layer membrane capacitor (Cmem) optimization for integrate-and-fire (I&F) neuron circuits to minimize the accuracy drop in spiking neural network (SNN). The fabricated synaptic transistor exhibited linear 32 synaptic weights with a large dynamic range ( 846), and an n-type-only IGZO I&F neuron circuit was proposed and verified by HSPICE simulation. The network, consisting of three fully connected layers, was evaluated with an offline learning method employing synaptic transistor and I&F circuit models for three datasets: MNIST, Fashion-MNIST, and CIFAR-10. For offline learning, accuracy drop can occur due to information loss caused by overflow or underflow in neurons, which is largely affected by Cmem. To address this problem, we introduced a layer-by-layer Cmem optimization method that adjusts appropriate Cmem for each layer to minimize the information loss. As a result, high SNN accuracy was achieved for MNIST, Fashion-MNIST, and CIFAR-10 at 98.42%, 89.16%, and 48.06%, respectively. Furthermore, the optimized system showed minimal accuracy degradation under device-to-device variation.

2 September 2024 in IEEE Journal of the Electron Devices Society
Verified
Journal Article
Open access
CPChanjin Park
Chanjin Park
HKHee-Ok Kim
Hee-Ok Kim
JYJong-Heon Yang
Jong-Heon Yang
JPJae-Eun Pi
Jae-Eun Pi
YKYong-Duck Kim
Yong-Duck Kim
SLSoo-Yeon Lee
Soo-Yeon Lee
In this paper, a new pixel circuit for active matrix organic light-emitting diode (AMOLED) display that can achieve high uniformity in low gray levels and its driving method are proposed. The proposed circuit compensates for threshold voltage variation of thin-film-transistors (TFTs), with the structure that minimizes the loss of sensed threshold voltage. However, the high current error rate in extremely low gray level is unavoidable, as the driving TFT (DRT) operates in subthreshold region, where the current difference caused by the threshold voltage variation can be severe. To suppress high error rates in low gray levels, the operation region of DRT is restricted to the saturation region, by adopting duty ratio modulation (DRM) method. With the DRM method, low gray is expressed with high current value and short emission time. The viability of the proposed circuit and its operation are analyzed with HSPICE. Compared to the conventional driving method, DRM significantly reduces the current error rate in low gray area. The proposed circuit is fabricated within 220 μm 440 μm. The measurement of the circuit also verified the capability of the proposed circuit and the DRM method.

20 September 2024 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
KKKyeong-Soo Kang
Kyeong-Soo Kang
HKHee-Ok Kim
Hee-Ok Kim
JYJong-Heon Yang
Jong-Heon Yang
JPJae-Eun Pi
Jae-Eun Pi
YKYong-Duck Kim
Yong-Duck Kim
SLSoo-Yeon Lee
Soo-Yeon Lee
In this article, we propose a pixel circuit suitable for depletion-mode oxide thin-film transistors (TFTs) to drive micro-light-emitting diode ( $\mu $ LED) with pulse width modulation (PWM). In the proposed pixel circuit, both the constant current generation (CCG) part and the PWM part compensate for the variation in the threshold voltage ( ${V}_{\text {TH}}$ ) of the driving TFT (DRT) through a source-follower structure and store the data voltage entirely without capacitive division. By avoiding voltage division, the data range and the corresponding control signal range can be reduced, lowering the switching power. The operation of the proposed pixel circuit is verified and compared with the conventional pixel circuit through simulation using HSPICE from Synopsys, employing an oxide TFT model based on measured data from the fabricated device. In addition, the proposed circuit is experimentally validated through circuit fabrication. Both simulation and experimental results exhibit consistent PWM driving, indicating accurate compensation for variations in both parts, along with enhanced operation.

22 March 2022
Verified
Book Chapter
Closed access
PDF file
DSDongwoon Song
Dongwoon Song
TKTAEWOONG KANG
TAEWOONG KANG
JYJaeBong Yi
JaeBong Yi
JKJoonyoung Kim
Joonyoung Kim
TKTaeyang Kim
Taeyang Kim
Seung-Joon YiSeung-Joon Yi
Seung-Joon Yi

1 May 2019
Verified
Conference Paper
Closed access
MKMinJi Kim
MinJi Kim
KYKyungJong Yoo
KyungJong Yoo
SYSangJae Yoo
SangJae Yoo
JWJungWon Woo
JungWon Woo
EKEun-Soo Kim
Eun-Soo Kim
IHInGab Hwang
InGab Hwang
In the field of electric vehicles, researches on wireless power transfer (WPT)charging system have been developed recently because of environmental problems and convenience. In this paper, we proposed a wireless power transfer charging system using a single stage AC/DC converter that can be reduced in size and weight, as well as ensuring convenience. The proposed single-stage AC/DC converter can control the wide output voltage (250 V DC ~ 350 V DC ) by the link voltage and pulsewidth voltage applied to CLLC resonant circuit through the phase-shifted modulation at a fixed switching frequency. Also, the input power factor (PF)and the total harmonic distortion (THD i )by using the proposed converter can be improved. A 1 kW prototype was fabricated and validated through experimental results and analysis.

24 November 2025 in Journal of the Society for Information Display
Verified
Journal Article
Open access
JKJaybum Kim
Jaybum Kim
KKKyeong‐Soo Kang
Kyeong‐Soo Kang
JPJi‐Hwan Park
Ji‐Hwan Park
CPChanjin Park
Chanjin Park
MKMinji Kim
Minji Kim
SLSoo‐Yeon Lee
Soo‐Yeon Lee
In this paper, we present an amorphous indium‐gallium‐zinc‐oxide (a‐IGZO) based pulse width modulation (PWM) pixel circuit for micro light‐emitting diode (micro‐LED) displays, designed to enhance low gray‐level expression. Conventional PWM circuits suffer from a long falling time, causing inaccurate gray‐level representation. To address this, the proposed circuit employs a continuous piecewise linear sweep signal with two distinct slopes: a steeper slope for low gray levels and a shallower slope for mid‐to‐high gray levels. This approach reduces the falling time from 209 to 62 μs, enabling accurate gray‐level expression down to 41 G without distortion. To prevent falling time distortion from sweep signal slope transitions, a newly proposed separation part divides the emission period into low and high gray phases. By maintaining a constant sweep signal slope within each phase, the circuit ensures stable emission and eliminates distortion. HSPICE simulation verifies the circuit operation and confirms that it maintains stable performance under threshold voltage variations.