12 March 2021 in IEEE Transactions on Microwave Theory and Techniques
This article presents a 60-GHz variable gain phase shifter (VGPS) with orthogonal phase and gain control technique and linear phase control technique in 65-nm CMOS. Using the orthogonal phase and gain control technique, the proposed VGPS has the ability of gain tuning without extra variable gain block, significantly reducing the size of conventional phased arrays. The linear phase control technique is proposed to greatly improve the accuracy and robustness of phase control against temperature variation. As results, the VGPS achieves 6-bit phase resolution across -25 °C to 110 °C and continuous gain tuning range of 14.8 dB. The measured 3-dB bandwidth is 52-64 GHz. As the gain of VGPS is -22.4 to -dB, the measured root-mean-square (rms) phase errors are 1.3°-3.3°, while the measured rms gain errors are 0.2-0.5 dB in 3-dB bandwidth. Across -25 °C to 110 °C, the variations of rms phase and gain errors are below 1.2° and 0.1 dB, respectively. With supply voltage varying from 1.0 to 1.2 V, the variations of rms phase and gain errors are below 1.1° and 0.2 dB, respectively. During the measurement with different combinations of temperature and supply voltage, no gain and phase calibrations are conducted. The measured input-referred P 1 dB at the maximum gain state (-7.6 dB) is about -3.8 dBm. The chip consumes 16.4 mA from a 1.1-V voltage supply and the core area of the VGPS is 720 μm ×560 μm.
22 September 2023 in IEEE Transactions on Microwave Theory and Techniques
A variable gain amplifier (VGA) featuring wide bandwidth and low phase variation is presented for the new generation phased arrays supporting multiple-frequency bands simultaneously. In this article, the mechanism of phase variation in common-source (CS) CMOS amplifier cell is investigated in detail. As revealed by this analysis, the parasitic capacitor C $_{\text{gd}}$ and the magnetic coupling among inductors as well as parasitic capacitors in layout inducing by interconnection lines are some of the key factors that generate feedforward signal, which leads to the phase variation. The other is the inconstant input and output admittance that result in phase deviation over a wideband region. To achieve low phase variation over broadband for CMOS CS VGA, an innovative phase compensation method based on feedforward signal suppression (FSS) and impedance-invariant techniques is proposed. Specifically, the active cross-coupling neutralization topology is employed to suppress the feedforward signal generated by C $_{\text{\rm gd}}$ . Meanwhile, an isolation enhancement layout approach aiming at mitigating the inductive coupling and parasitic capacitors in layout is proposed. Besides, a control circuit based on the impedance-invariant technique is developed to minimize the impedance variation. As a result, a low phase variation VGA with broadband phase compensation is achieved. The measured gain control range is 23 dB, with a 3-dB bandwidth of 20–43 GHz and a peak gain of 15 dB. The measured phase variation is $<$ 2 $^{\circ}$ in 18–36 GHz and $<$ 6 $^{\circ}$ across 18–45 GHz. The noise figure and input-referred P $_{\text{1\,dB}}$ are 5.5 dB and $-$ 18 dBm in the maximum gain state, respectively. The measurement also shows the proposed VGA has good robustness against the variation of supply and temperature. The VGA consumes 30.8 mW from a 1.1-V voltage supply. The chip is fabricated in a standard 65-nm CMOS process and the core area is 0.34 mm $^{\text{2}}$ .
13 January 2020 in IEEE Access
29 August 2020 in Microwave and Optical Technology Letters
23 January 2021 in Microwave and Optical Technology Letters