1 July 2019 in Journal of Physics: Conference Series
Existing WiFi mesh networks are usually implemented on high-end or PC grade platforms. However, the open source community has been recently developing a unique mesh network library targeted for the low-cost and resource limited ESP8266 platform. The so called painlessMesh library enables two or more ESP8266 modules to self-configure and to form a WiFi mesh network. This might open up new potential for the ESP8266 to be used in wider application areas. The library is in an early development stage and not much is known about its performance. Therefore, this paper aims to evaluate to what extent the ESP8266 painlessMesh network can perform, in terms of one-way delay and data rate. Measurements showed that a 2-node network has a delay of 2.49 ms. A network consisting of higher number of nodes tends to have an increased network delay even for the same hop distance. Meanwhile, data rate measurements showed that for the case of 10-byte payload a node can receive up to 461 messages/sec. Whereas for payload of 4400 bytes, the node can receive up to 28 messages/sec. Furthermore, it can be reported that payload greater than 4400 bytes starts causing incomplete and erroneous messages.
1 February 2024 in International Journal of Electrical and Computer Engineering (IJECE)
The increasing complexity of electrical and electronic systems in unmanned aerial vehicles (UAVs) has raised concerns regarding unwanted electromagnetic interference (EMI) due to limited compartment space. Recent studies have highlighted the UAV cabling as the primary pathway for interference. This paper presents a novel approach to investigating the effects of interference power, polarization angle, and distance from the interference source on EMI in UAV cable systems. Measurements and simulations were performed to analyze the influence of these factors on the radiation received by the cable. A linear dipole antenna, operating at a frequency of 905 MHz, served as the radiation source, while a single wire cable pair terminated with a 50-ohm resistor was employed as the victim. The findings reveal that the power transmitted by the source, the distance between the cable and the source, and the polarization angle have a significant impact on the electromagnetic interference received by the cable. Notably, a perpendicular orientation of the cable to the interference source (antenna) in the far-field yielded a reduction of up to 15 dBm in EMI. The results underscore the necessity for more sophisticated models and comprehensive measurements to fully comprehend the diverse factors affecting polarization losses in practical scenarios.
1 July 2016 in Indonesian Journal of Electrical Engineering and Computer Science
Pulsed electric fields (PEF) is a novel non-thermal food processing whose purpose is inactivating microbes while at the same time preserving food’s nutrition, color, and taste. This paper presents an analysis of step up transormer for PEF high voltage generator. To achieve the optimum PEF effects, the pulse shape should resemble a square, which is characterized by low voltage drop and fast rising time. Through simulations, it has been shown that higher transformer inductance results in lower voltage drop. However at some points, further increasing the inductance would only produces negligible improvements. Meanwhile fast rising time can be achieved by minimizing leakage inductance and parasitic capacitance. Moreover, maximum energy transfer to the load can be obtained by reducing winding resistances. Finally, a case of high voltage generator using ignition coil has been evaluated. Due to its high winding resistances, ignition coil seems to be not suitable for PEF applications.