16 August 2021 in IEEE Electron Device Letters
Hot-carrier-induced degradation of short p-channel field-effect transistors in the presence of externally applied vertical mechanical force is investigated. The mechanical stress was induced in the devices by applying a normal load with a nanoindenter. Using finite element modeling, the induced stress to the channel was estimated to reach GPa range. It is shown that compressive mechanical stress considerably enhances the impact ionization rate and the generation of secondary electron-hole pairs. These can be trapped in the gate oxide and cause a hot-electron-induced punch-through effect and effective p-channel length reduction even after both mechanical and electrical stresses are removed. The presented findings indicate the importance of mechanical stress control and engineering for improving the device reliability.
3 August 2023 in IEEE Transactions on Electron Devices
The main limitations of the current dynamic random access memory (DRAM) technology are its scalability and power consumption. These constraints can be overcome by using an In–Ga–Zn–oxide (IGZO) transistor that offers a low OFF-current and high scalability. For that, the IGZO device performance needs to be optimized, which includes increasing its $\textit{I}_{\biosc{on}}$ and $\textit{V}_{\text{TH}}$ . By combining experiments on scaled industry-relevant devices with ab initio calculations, we show that IGZO composition impacts $\textit{I}_{\biosc{on}}$ and $\textit{V}_{\text{TH}}$ through modifying channel mobility and carrier concentration. In the studied composition range, $\textit{I}_{\biosc{on}}$ increases with higher In % and lower Ga %, which is opposite to the $\textit{V}_{\text{TH}}$ trend. Scanning the whole IGZO composition space with ab initio calculations, we predict that films with In $<$ 10% and 20% $<$ Ga $<$ 80% might be beneficial for improving $\textit{I}_{\biosc{on}}$ and $\textit{V}_{\text{TH}}$ .
30 September 2020 in IEEE Transactions on Electron Devices
This work experimentally investigates current conduction in 3-D nand under up to 7 GPa of externally applied compressive mechanical stress. The impact of channel crystallinity and geometry is studied by comparing four types of Si channels: polycrystalline full channel, single-crystal full channel, polycrystalline macaroni channel, and single-crystal macaroni channel. In the studied channel types, the mechanical stress was found to cause reversible degradation of Ion (up to one order of magnitude) and Ioff (up to seven orders of magnitude). Using TCAD simulations, Ion and Ioff deterioration are attributed to carrier mobility and Si bandgap decreases under mechanical stress, respectively. The simulations also suggest that both effects depend on the channel morphology, which results in a different extent of stress impact on the four studied types of Si channels.
9 March 2022 in IEEE Transactions on Electron Devices
The impact of mechanical stress (MS) on MOSFET gate-induced drain leakage (GIDL) current is investigated. The tests were performed on planar short-channel p- and n-type MOSFETs. Vertical compressive MS was induced in the devices by applying a vertical load with a nanoindenter. The applied stress was ranging from several hundred MPa to a GPa range, estimated by finite-element modeling. It is reported that GIDL current increases exponentially with MS. This effect is attributed to MS-induced reduction in the silicon bandgap and effective mass, leading to enhanced band-to-band tunneling (BTBT). Furthermore, the GIDL currents are found to change depending on the location where the vertical force is applied, with a higher influence of force on GIDL above the channel.
28 April 2025 in ACS Applied Electronic Materials
17 April 2025 in ACS Applied Electronic Materials