Erica Treflik-Body

Erica Treflik-Body

Auto-generated profile, based on publicly available information

Erica Treflik-Body

Queen’s University

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 May 2024 in Journal of Geophysical Research: Oceans
Verified
Journal Article
Open access
ETE. Treflik‐Body
E. Treflik‐Body
ESE. Steel
E. Steel
WTW. A. Take
W. A. Take
RMRyan Mulligan
Ryan Mulligan
Climate change is making coastal regions increasingly vulnerable to hazards, including rapid subaerial and submarine landslides, which can result in catastrophic tsunamis. Due to the complex geomechanics of failure, limited physical modeling studies have been conducted that encompass the entire problem including the triggering of granular landslides, the waves generated by partially and fully submerged mass failures, and the runup of these waves on local and distal slopes. In the present study, for the first time, waves in both the seaward direction (in the direction of failure for both submarine and partially submerged slides) and the landward direction (opposing the direction of failure only for submarine slides) are investigated during morphological evolution of the granular material. A series of large‐scale experiments are conducted under varying levels of submergence in water by releasing columns of gravel‐sized material into a range of different reservoir depths. This is accomplished using a pneumatically actuated vertical lift gate designed specifically for these experiments. The wave amplitudes measured in the seaward direction agree with empirical relationships developed in a previous study using smaller‐scale models, and a new analytical solution relating the column submergence to the trough‐led wave amplitudes in landward direction is presented. These novel predictions of wave amplitude and runup in both the seaward and landward directions indicate strong dependence of the wave behavior on the submergence depth and granular properties, improving our understanding of tsunamis generated by mass failures in coastal regions.

1 January 2025 in Canadian Geotechnical Journal
Verified
Journal Article
Open access
AFA. Fawley
A. Fawley
ATA. Taylor-Noonan
A. Taylor-Noonan
LTL. Tauskela
L. Tauskela
ETE. Treflik-Body
E. Treflik-Body
WTW.A. Take
W.A. Take
Laboratory landslide flume studies have revealed that saturated granular flows experience greater mobility than their dry counterparts, being notably faster, farther reaching, and experiencing enhanced spreading. The ability to reliably measure basal pore water pressures is critical for developing, evaluating, and validating constitutive relationships linking the effects of pore pressure to the mechanisms causing increased mobility. Unfortunately, experience has shown that two identical sensors installed in the base of a landslide flume can yield wildly different responses to the same multi-phase landslide. In this paper we explore the hypothesis that the elevation of pore water pressure sensor filter elements can influence sensor readings. A unique experimental strategy of simplifying the flow into a single fluid phase is used to validate sensor readings, prior to application in multi-phase flows. Dam-break releases of 600 kg of water at the top of the inclined flume slope are used as a parametric study to provide evidence to support the hypothesis that sensor roughness significantly impacts the pore pressure recorded in high velocity flows. These results are then contrasted to observations of releases of multi-phase flows to derive best practices for the reliable measurement of pore pressure in landslide flume tests.

1 January 2026 in Canadian Geotechnical Journal
Verified
Journal Article
Open access
ETE. Treflik-Body
E. Treflik-Body
IOI. Omer
I. Omer
MTMark Talesnick
Mark Talesnick
ESE. Steel
E. Steel
RMRyan Mulligan
Ryan Mulligan
WTW.A. Take
W.A. Take
This work explores the phenomena of instability in low stress tilt-testing of dry sands using novel imbedded shear stress and strain sensors to capture quantitative data of constitutive behaviour leading up to and during instability. A unique strategy of testing dry soil enabled the investigation of instability in isolation from pore pressure consequences. Six shear stress and shear distortion sensors were distributed along the transparent sidewall and centre of the tilt-table, which was then rotated until instability and failure. Shear strain measured next to the transparent sidewall were 50% of those measured along the table centerline. Friction reduction strategies were successful in significantly reducing, but not eliminating, this discrepancy. Soil layers tilted until reaching instability, unloaded, and subjected to a second tilt cycle only exhibit instability at angles in excess of the first instability event. This phenomenon, analogous to the Kaiser effect, reveals the importance of void ratio with respect to instability. Tilt-table testing, when equipped with internal shear distortion sensors, was shown to be able to capture the modulus degradation curve over the strain range of 10 −5 to 10 −1 providing a promising new experimental technique to explore the stiffness degradation curve at very low confining pressures.

15 May 2023
Verified
Conference Paper
Open access
AFAmanda Fawley
Amanda Fawley
ATAlexander Taylor-Noonan
Alexander Taylor-Noonan
LTLisa Tauskela
Lisa Tauskela
ETErica Treflik-Body
Erica Treflik-Body
WTW. Andrew Take
W. Andrew Take
Laboratory landslide flume tests provide valuable insights into the mechanics of multi-phase granular flows within highly controlled settings. Past studies have revealed the complex fluid-particle interactions associated with saturated granular flows result in greater mobility than their dry counterparts, being notably faster, further reaching, and experiencing enhanced spreading. The ability to reliably measure the pore pressures at the base of these flows in the laboratory is critical for developing, evaluating, and validating constitutive relationships linking the effects of pore pressure to the mechanisms causing increased mobility. Unfortunately, experience has shown that two identical sensors installed in the base of a landslide flume can yield wildly different responses to the same multi-phase landslide. In this session, we explore an answer to the question “Why is it so difficult to reliably measure the pore pressure at the base of a fast landslide in a laboratory flume test?” using evidence accumulated from ten years of flume testing using the Queen’s University Landslide Flume. In particular, we explore the hypothesis that surface roughness around pore pressure sensor filter elements can influence sensor readings. A unique experimental strategy of simplifying the flow into a single fluid phase is used to validate sensor readings, prior to application in multi-phase flows. Dam-break releases of 600 kg of water at the top of the inclined flume slope are used as a parametric study to provide evidence to support the hypothesis that surface roughness significantly impacts the pore pressure recorded in high velocity flows. These results are then contrasted to observations of releases of multi-phase flows to derive best practices for the reliable measurement of pore pressure in landslide flume tests.

15 May 2023
Verified
Conference Paper
Open access
ETErica Treflik-Body
Erica Treflik-Body
ESElisabeth Steel
Elisabeth Steel
ATAndy Take
Andy Take
RMRyan Mulligan
Ryan Mulligan
Under changing climate, coastal regions are increasingly vulnerable to a variety of hazards, including rapid subaerial and submarine landslides. These hazards can generate tsunamis and dense turbidity currents, which threaten both onshore and offshore infrastructure. Due to the complex geomechanics of failure, limited physical modelling has been conducted that encompasses both the triggering of granular landslides and subsequent waves associated with partially and fully submerged mass failures. Further, experimental modelling of submerged failures has primarily focused on the waves generated in the direction of failure (seaward) and not on the waves formed above and behind the failure (shoreward). To this effect, a series of large-scale granular collapse experiments were conducted by releasing 0.75 m and 0.5 m tall columns of 9.25 mm nominal diameter river stone into reservoir depths ranging from 0.20 m to 1.10 m to explore the wave generation and runup processes in both seaward and shoreward directions. The columns were released by a pneumatically-actuated vertically rising gate designed for the 2.10 m wide and 1.20 m high glass-walled flume. The gate lifts rapidly in 0.7 s, which enables the instantaneous loss of support of the source volumes and results in granular collapse. The wave amplitude is measured using wave capacitance gauges and the failure mechanics are captured with high speed cameras. Overall, the wave amplitudes measured in these highly instrumented large-scale physical models are in good agreement with empirical relationships developed in a previous study using smaller-scale models. The large-scale experimental results provide insight and opportunity to develop relationships between the initial column submergence depth and the magnitude of the shoreward propagating waves, which has previously not been explored. Connecting the amplitude of the waves with the tsunamigenic potential for partially to fully submerged granular materials will assist in understanding risk to offshore infrastructure and communities in coastal regions.