Impulse motion characterized by a large amplitude in the fault‐normal direction can be observed at near‐fault strong motion sites during strike‐slip earthquakes. The large pulse, which always causes high intensity and stronger damage to structures close to faults, is usually attributed to the directivity effect of rupture propagating along strike and the proximity to the fault. We present an analysis of such a large directivity pulse captured by the near‐fault high‐rate Global Navigation Satellite System (GNSS) during the 2022 6.7 Luding, China, earthquake—the largest event ever observed by space geodesy on the seismically active Xianshuihe fault in the eastern Tibetan Plateau. We invert the displacement waveforms and offsets derived from the continuous and campaign GNSS for the rupture kinematics. The inferred slip model reveals a rupture zone of 30 km in length above 15 km depth along the Moxi segment, yielding a seismic moment of and a source duration of 13 s. The high‐rate GNSS (hrGNSS) waveforms suggest an asymmetric bilateral rupture: most slips with long rise time are concentrated on the southern part of the ruptured fault, whereas a short‐duration pulse‐like slip rate with low final slip propagates during the northward rupture. We found that the directivity pulse observed by the nearest hrGNSS site is controlled primarily by the sharp pulse‐like slip rate and rapid rupture velocity approximating the local S‐wave velocity. Along with additional local amplification, this large directivity pulse may be responsible for the heavy damage in Moxi town close to the northern ruptured fault.
We use surface deformation measurements, including Interferometric Synthetic Aperture Radar data acquired by the Sentinel‐1A satellites and Global Navigation Satellite System observations, to invert the fault geometry and coseismic slip distribution of the 2022 6.6 earthquake in Sichuan, China. The dip of the best‐fitting model is 68°. The rupture of the 2022 Luding earthquake is dominated by northwest strike‐slip movement, mainly concentrated over a length of about 20 km above a depth of 15 km. The maximum slip is at approximately 4 km depth with the maximum displacement of about 2.1 m. The results indicate that the 2022 Luding earthquake ruptured the shallow layer of the seismic zone. The slip distribution indicates that the Moxi–Shimian fault segment is fully locked from the surface down to 15 km, which is consistent with the estimated locking depth. Based on the Coulomb stress analysis and considering the strong locking state of the Anninghe fault, more attention should be paid to the possibility of earthquakes in the Anninghe fault.
On 28 March 2025, a devastating Mw 7.7 earthquake struck the central and southern segments of the Sagaing fault in Myanmar and led to the largest surface rupture length of over 500 km ever documented for a strike-slip event. Here, the Synthetic Aperture Radar images from Sentinel-1A/B satellites were processed using the pixel offset tracking (POT) method to retrieve high-resolution coseismic displacements of the 2025 Mw 7.7 Mandalay earthquake. By integrating Differential Interferometric Synthetic Aperture Radar, aperture interferometry, and POT observations, we quantified the near-field on-fault and off-fault deformation patterns and constrained fault geometry and slip distribution of the Mandalay earthquake. The results show that the rupture of the Mandalay earthquake is dominated by right-lateral strike-slip motions with the maximum slip of ∼6 m located in the shallowest part. The shallow slip deficit of the Mandalay earthquake is small (<15%), consistent with the generally small diffuse deformation on the off-fault damage zones. We also inverted the interseismic coupling distribution on the Sagaing fault constrained by updated Global Navigation Satellite Systems velocities. The result indicates that the coseismic slip of the Mandalay earthquake did not penetrate deeper than the regional seismogenic layer, exhibiting high spatial correlation with interseismic strongly coupled patches on the Sagaing fault. The rupture of the Mandalay earthquake nucleated in a transitional area with heterogeneous stress distribution caused by a rapid change of fault coupling depth on the fault plane. Coulomb stress analysis indicates increased loading on the southern Nay Pyi Taw and northern Sagaing fault segments, implying elevated seismic hazard in these areas. Considering the strong coupling of adjacent segments and the dense population in central Myanmar, heightened attention to future earthquake potential is warranted.
Seismogenic depth is a fundamental parameter in seismic hazard assessment and is commonly inferred from kinematic approaches that rely on empirically defined thresholds. However, these observational estimates require validation and calibration against physics-based earthquake cycle models. Here we focus on the San Andreas Fault system in California, where high-quality geodetic, seismicity, and geothermal datasets are available. We construct a geodetically derived fault-coupling model for the entire fault system and systematically compare seismogenic depths inferred from fault coupling with those constrained by earthquake depth distributions. Our results show that a geodetic seismogenic depth defined by a coupling ratio of 0.45 provides the closest agreement with the depth enclosing 90% of the observed seismicity. This correspondence is quantitatively consistent with predictions from thermally constrained rate-and-state friction models, although the numerically inferred seismogenic depths are systematically shallower. Along-strike variations in seismogenic depth obtained from all approaches exhibit similar spatial patterns and correlate strongly with geothermal gradients, indicating that temperature is the primary controlling factor. These results establish a quantitative link between seismogenic depths derived from observational constraints and physics-based numerical models, thereby providing a stronger physical basis for incorporating geodetically inferred coupling models into seismic hazard assessments.