18 August 2023 in IEEE Transactions on Instrumentation and Measurement
This paper presents a multi-static or multiple input output (MIMO) antenna array millimeter wave imaging system operating in the Ka-band (26.5-40 GHz) frequency range. This imaging system consists of eight 1-D arrays each containing 32 transmitters and 32 receivers for a total of 256 transmitting and 256 receiving antennas, each of which is independently addressable. By scanning the imaging system over a 1-D line path, a dense multi-static imaging aperture can be synthesized and used to generate high-resolution (sub-wavelength) 3-D synthetic aperture radar (SAR) images in the near-field of the array. In this work, the design of the imaging system is detailed, including the 1-D linear array layout, the antenna element design, and various other supporting components. The imaging methodology used to create SAR images is detailed as well. The calibration process used to calibrate the imaging system is explained, and some relevant calibration results are shown. Subsequently, several imaging experiments are performed, the results of which demonstrate the capabilities of this multi-static imaging system. These SAR images specifically showcase the effectiveness of multi-static SAR measurements for near-field imaging. Additionally, several experiments are performed to showcase the utility of the imaging system for nondestructive testing (NDT) and security inspection purposes.
19 December 2006 in IEEE Transactions on Magnetics
Insights from recovered armatures suggest re-examining historical modeling assumptions for railguns. The finite-element codes EMAP3D and DYNA3D were linked to explore the effects of temperature-dependent material properties, thermal diffusion, armature wear, inertial loading, thermal stresses, and 2-D model approximations. Temperatures and principal stresses for each of these cases were compared. Thermal diffusion and thermal stresses in armatures cannot be ignored past the first millisecond of launch; material properties under pulsed heating can significantly differ from equilibrium and room-temperature values. Armature wear and inertial loading can be ignored at low speeds, but not at high speeds (>1 km/s). Models in 2-D can approximate 3-D models with appropriate boundary conditions, but only for the first few milliseconds of launch. With a detailed EMAP3D model and minimal assumptions, simulations that agree within a few percentage points of microstructural measurements from recovered armatures are possible