In permanent magnet synchronous machines (PMSMs), the harmonic currents induced by harmonic back electromotive force (BEMF) and the inverter nonlinearity are inevitable. Existing methods typically rely on the design of high-performance controllers for harmonic suppression, which inevitably requires complex parameter tuning. In contrast, parameter identification methods, widely used in machine control, can achieve high-performance control while avoiding complex parameter tuning. However, there is a lack of methods that apply parameter identification for harmonic suppression. Consequently, this article models the harmonic voltages caused by the inverter nonlinearity, dq circuit cross coupling, and harmonic permanent magnet flux linkage as the virtual harmonic BEMF. Furthermore, this article proposes a harmonic current suppression method based on the 2-D identification of virtual harmonic BEMF. The proposed method utilizes only two integral regulators to achieve static-errorless identification of the amplitude and phase of the virtual BEMF while simultaneously ensuring static-errorless suppression of the harmonic currents. Furthermore, this article also considers the impact of system delay and incorporates compensation. Finally, the effectiveness of the proposed method is verified experimentally.
15 April 2025 in IEEE Transactions on Industrial Electronics
The zero-sequence current (ZSC) in the zero-sequence loop (ZSL), which is inherent in open-end winding permanent magnet synchronous machine (OW-PMSM) drives with a common dc bus, increases the torque ripple and the system loss. The simultaneous control of dual inverters and the ZSL complicates the pulse width modulation (PWM) method. This article proposes a double-symmetrical-voltage placement PWM (DSVP-PWM) method based on phase-voltage-independent control. This method significantly reduces the calculation time of the modulation and achieves the equivalent effect of the traditional space vector pulse width modulation (SVPWM). Furthermore, the effect of different voltage placements on the current ripple is discussed. Compared to the traditional SVPWM method, the proposed DSVP-PWM method leverages the characteristic of phase-voltage-independent control in OW machines and demonstrates enhanced universality for various OW machines. Finally, the effectiveness of the proposed method is verified experimentally.