26 December 2019 in IEEE Transactions on Instrumentation and Measurement
Eddy current heating with synchronized thermography (ST) is utilized for the contactless characterization of flexible hybrid electronics. A proposed approach is used for analyzing the uniformity of large area electronics being the basis for the quality assurance of hybrid electronics manufacturing. Flexible polymer substrate with printed conductors, bonded conventionally manufactured light-emitting diode (LED) chips and current regulators were used as test samples. Obtained results show that ST with eddy current heating is an effective and roll-to-roll compatible measurement tool for in-situ quality monitoring of hybrid electronics manufacturing.
7 May 2020 in IEEE Transactions on Electron Devices
Capability of high-speed and low-cost manufacturing makes the printing techniques a very promising approach for large-area flexible electronics mass manufacturing. Due to fast and intensive technology development, the lack of knowledge about the reliability and lifetime of printed electronics is obvious, requiring further investigation. Especially, the effect of torsional bending on lifetime is a mostly unexplored field of reliability testing. In this article, a torsional bending test of parallel printed silver conductors (0.3-, 0.5-mm pitch) on polymer substrate (polyethylene terephthalate, 125-μm thickness) was conducted and analyzed. According to the experimental results, torsional bending causes wear-out type failures in conductors and the length-to-width (LTW) ratio of the sample's substrate was observed to have a significant impact on reliability. If the LTW ratio is smaller than 3, the lifetime of printed conductor seems to collapse and samples lasted for approximately only 17 bending cycles on average. Lifetime was improved by increasing the LTW ratio and samples withstood over hundreds of cycles with LTW ratio of higher than 15. However, the distance of a conductor from the edge of the substrate was not observed to have any significant influence on the reliability under torsional bending.
15 May 2019 in Optics Letters
Testing and characterization techniques intended for traditional electronics production are rarely compatible with modern large-area, thin film electronics manufacturing processes such as roll-to-roll fabrication. Online quality monitoring of conductive thin films is necessary for upscaling and maintaining high-yield production. Thermography has already shown its usefulness in these kinds of applications, but has suffered from the lack of proper non-contact electrical heating. Now a fully contactless quality inspection technique based on thermal imaging and induction heating is implemented and evaluated. This approach is capable of discovering defected areas and estimating conductivity degradation online with full coverage over conductive thin films.
8 December 2020 in IEEE Transactions on Instrumentation and Measurement
Hybrid structural electronics (HSE) consists of printed electronics, conventional rigid electronics and load bearing supporting parts of a device (plastic, glass etc.). Extra-large area and flexible lighting elements with embedded light emitting diodes (LEDs) are an example of such applications. LEDs can be used e.g. as light sources to create smart surfaces for the architectural or automotive industry. Once the LEDs are embedded into the structure, they cannot be replaced. In order to make sustainable HSE products with long lifetime, the new type of designs is needed. The elements of HSE undergoes conditions with elevated thermal stresses while in operation. That is known to have an impact on their performance and lifetime, thus making a proper heat management of the LED crucial. Due to the novel additive manufacturing methods, structures, and unconventional material combinations, many thermal management related aspects are not known. In this study, a two-step hybrid method, including thermal modelling and measurements, is utilized to estimate thermal behavior of a surface mounted LED on polymer substrate used in HSE. The model is created and simulated in COMSOL Multiphysics. The validity and accuracy of the model’s thermal behavior is verified through measurements with thermal transient measurements. Based on the experimental verification, the proposed simulation model only has small (less than 2 %) temperature variations when compared with measurements. Hence, the developed model can be used as a basis for designing structural LED elements and predicting their performance characteristics in different user cases.
1 January 2026 in IEEE Pervasive Computing