Although nanotube is among the most effective morphology of Titania due to its unilateral pathway for photo-generated charge transfer and mechanical stability, its performance is still hampered by high recombination. In the present study, to further improve the photocatalytic degradation performance of Titania, univalent elements of H and Na were respectively ion-exchanged into the Titania nanotubes (TNTs). The photocatalyst was characterized using XRD, TEM, ICP-AES, and FTIR. The modified samples displayed enhanced photocatalytic degradation performance over Degussa TiO2 under UV-A light illumination of MB. The rate constants of NaTNT and HTNT were 16 and 13 times that of Degussa TiO2. Specifically, the Na-TNTs showed better photocatalytic degradation activity than H-TNTs with a rate constant of 0.12 min-1 while the latter showed 0.09 min-1. The optimum adsorption and photocatalytic performance of NaTNT were determined at pH 6 achieving about 99% MB removal within 10 min of irradiation. The ion exchange NaTNT displayed excellent reusability after the fifth cycle of the photocatalytic tests and superoxide radicals were experimentally determined to be the main reactive oxygen species involved in the photocatalytic degradation of MB.
Lithium bis(fluorosulfonyl)imide (Li-TFSI) is an efficient p-dopant that has been used to enhance the conductivity of perovskite solar cells (PSCs). However, the performance of the corresponding devices is still not satisfactory due to the impact of Li-TFSI on the fill factor and the short-circuit current density of these PSCs. Herein, a new Mn complex [(Mn(Me-tpen)(ClO4)2−)]2+ was introduced as a p-type dopant into spiro-OMeTAD and was successfully applied as a hole transport material (HTM) for PSCs. Analytical studies used for device characterization included scanning electron microscopy, UV–Vis spectroscopy, current–voltage (IV) characteristics, incident photon to current efficiency, power conversion efficiency (PCE), and electrochemical impedance spectroscopy. The UV–Vis spectra displayed oxidation in the HTM by the addition of a dopant. Moreover, the movement of electrons from the higher orbital of the spiro-OMeTAD to the dopant stimulates the generation of the hole carriers in the HTM, enhancing its conductivity with outstanding long-term stability under mild conditions in a humid (RH ∼ 30%) environment. The incorporation of the Mn complex into the composite improved the material’s properties and the stability of the fabricated devices. The Mn complex as a p-type dopant for spiro-OMeTAD exhibits a perceptible PCE of 16.39% with an enhanced conductivity of 98.13%. This finding may pave a rational way for developing efficient and stable PSCs in real environments.
11 August 2025 in Journal of Environmental Management
For the first time, groundwater treatment sludge was integrated with g-C3N4 towards highly efficient and cost-effective visible-light-initiated catalysts for organic removal. The optimized sample of g-C3N4/GWS-M(2.5 %), which was synthesized using the sludge rich in Al and Fe, was explored with improved photocatalytic activity. Its photocatalytic performance was ∼6, 4, and 7 times that of g-C3N4 in terms of removal of methyl orange, cephalexin, and ketoprofen, respectively. The observed greater photocatalytic activity was attributed to its upgraded physicochemical properties, including specific surface area, porous structure, visible light absorption, charge separation and transfer. In particular, the co-existence of dominant Al and Fe dopants in g-C3N4/GWS-M(2.5 %) aided abstraction of photogenerated charge carriers. After photocatalytic reaction, only 0.02 % and 0.01 % loss of Al and Fe was observed from the catalyst, respectively. A superior organic removal (∼92 %) was still observed by using g-C3N4/GWS-M(2.5 %) with no change in its crystal and chemical structures at the 5th cycle of photocatalytic degradation. The primary reactive species responsible for the reaction were inferred to be the superoxide and singlet oxygen radicals.