The ESD effects on the E-mode AlGaN/GaN high-electron mobility transistors (HEMTs) with p-GaN gate are investigated under repetitive TLP pulses. Firstly, the degradation and recovery of output, transfer characteristics, gate-leakage characteristics and low-frequency noises (LFN) are analyzed in detail before and after reverse electrostatic discharge (ESD) stress. The experimental results show that the electrical characteristics of the devices gradually degraded as the transmission line pulse (TLP) pules increased. Subsequently, the LFN measurements are performed over the frequency range of 1 Hz-10 KHz by increasing TLP pulses. Finally, the recovery tendency of DC (direct current) characteristics and trap density are studied and discussed after resting the device at room temperature for 1 to 3 months. These results physically confirm that the mechanism of the performance degradation and recovery of the devices could be attributed to the trapping and releasing processes of electrons in the p-GaN layer and AlGaN barrier layer of AlGaN/GaN HEMTs, which change the electric field distribution under the gate.
22 December 2020 in IEEE Transactions on Electron Devices
In this article, the degradation behavior of the commercial 1.2-kV SiC power MOSFETs was investigated under repetitive power-cycling stress, and defect analysis based on low-frequency noise (LFN) was carried out. The experimental results show that increasing power-cycling stress results in a forward shift of threshold voltage and increasing on-resistance. Meanwhile, the drain-to-source current significantly decreases with the increase of the cycles. Furthermore, the gate-source leakage current of the device became larger and the blocking characteristics deteriorated after 10-k cycles. The negative shift of the gate-capacitance versus gate-voltage curve was analyzed. Trap characterization was performed by using the LFN method, and it was found that the trap density of the device increased 5.47 times after 10-k cycles. The physical mechanism could be attributed to electrically active trapped charges generated at the SiC/SiO₂ interface during power-cycling stress. This article may be helpful for degradation detection and fault analysis of SiC power MOSFETs in the electronic system.
Despite the superior working properties, GaN-based HEMTs and systems are still confronted with the threat of a transient ESD event, especially for the vulnerable gate structure of the p-GaN or MOS HEMTs. Therefore, there is still an urgent need for a bidirectional ESD protection diode to improve the ESD robustness of a GaN power system. In this study, an AlGaN/GaN ESD protection diode with bidirectional clamp capability was proposed and investigated. Through the combination of two floating gate electrodes and two pF-grade capacitors connected in parallel between anode or cathode electrodes and the adjacent floating gate electrodes (CGA (CGC)), the proposed diode could be triggered by a required voltage and possesses a high secondary breakdown current (IS) in both forward and reverse transient ESD events. Based on the experimental verification, it was found that the bidirectional triggering voltages (Vtrig) and IS of the proposed diode were strongly related to CGA (CGC). With CGA (CGC) increasing from 5 pF to 25 pF, Vtrig and IS decreased from ~18 V to ~7 V and from ~7 A to ~3 A, respectively. The diode’s high performance demonstrated a good reference for the ESD design of a GaN power system.
30 December 2020 in Semiconductor Science and Technology
During no or minimal avalanche capability, the surge ruggedness of the E-mode AlGaN/GaN high-electron mobility transistors (HEMTs) with p-GaN gate has not been fully understood. This work unveils the comprehensive results from repetitive unclamped inductive switching (UIS) measurements on commercial p-gate GaN HEMTs. The Electrical parameters degradation and recovery characteristics have been investigated. Firstly, a careful study has been made about the degradation of output, transfer, gate leakage, and gate capacitance parameters of GaN HEMT devices before and after repetitive UIS pulses, which acting on the device channel. With the help of the low-frequency noises (LFNs), the test results show that the device characteristics have gradual degradation with an increase in UIS pules, including increased threshold voltage ( Vth ), and decreased gate leakage current ( Igss ). Subsequently, the LFN testing is carried out with the increase of UIS pulses. Finally, the recovery characteristics of the devices are studied and the physics associated are discussed after putting the device at room temperature in the air for 1–15 d, which includes DC characteristics and trap density. These results physically confirm that the mechanism of the degradation and recovery of device characteristics, that is the charge trapping effects of electrons. After repetitive UIS stresses, the electrons are trapping and de-trapping on interfaces and in the bulk layer of devices, which can change electric field distribution below the grids. These have a strong impact on the electrical performance of devices.
30 November 2021 in Journal of Physics D: Applied Physics
In this work, investigation on the degradation behavior of 1.2 kV/52 A silicon carbide (SiC) power MOSFETs subjected to repetitive slow power cycling stress has been performed. Electric characteristics have been characterized periodically over the stress and the respective degradation mechanisms have also been analyzed. A comprehensive degradation analysis is further conducted after the aging test by virtue of the x-ray inspection system, scanning acoustic microscope, scanning electron microscope, emission microscope, etc. Experimental results reveal that both the degradation of the gate oxide on the chip-level and the degradation of the bond wire and solder layer on the package-level have emerged over the cyclic stress. Specifically, growths of threshold voltage (Vth) and gate leakage current (Igss) are thought to be relevant with the degradation of gate oxide by SiC/SiO2 interface states trapping/de-trapping electrons on the chip-level, while the appearance of fatigue in the bond wire and the delamination of the solder layer imply the degradation on the package-level. This work may provide some practical guidelines for assessments of the reliability of SiC power MOSFETs in power conversion systems.
19 February 2020 in Journal of Physics D: Applied Physics
In this letter, the degradation and recovery characteristics of E-mode AlGaN/GaN high-electron mobility transistors (HEMTs) were investigated under repetitive short-circuit (SC) stress. Output, transfer, transconductance and gate-leakage characteristics were analyzed in detail before and after repetitive SC stress. After stress, the electrical characteristics of the devices gradually degraded as the SC pules increased. Low-frequency noise measurements are performed over the frequency range of 1 Hz–10 KHz by increasing SC pulses. Furthermore, the recovery tendency of DC characteristics and trap density is observed between repetitive SC measurements, and this physically confirms that the mechanism of the performance degradation could be attributed to the trapping and releasing processes of electrons in the p-GaN layer and AlGaN barrier layer of AlGaN/GaN HEMTs, which change the electric field distribution under the gate.