22 May 2023 in Applied Physics Letters
We demonstrate an ion-implanted triple-zone junction termination extension (JTE) for vertical GaN p-n diodes. Due to the spatial distribution of fixed charge in the triple-zone JTE structure, the peak electric fields at the contact metal edge and at the edge of the JTE are significantly reduced compared to conventional approaches. The forward and reverse characteristics of diodes with conventional single-zone JTE and the triple-zone JTE explored here have been studied and compared experimentally. GaN p-n diodes fabricated using the triple-zone JTE obtain an experimentally measured maximum breakdown voltage of 1.27 kV, appreciably higher than the 1.01 kV achieved using the single-zone JTE structure. The triple-zone JTE design also provides a wider window for fabrication processing and epitaxial wafer growth to achieve the high breakdown voltage compared to single-zone designs. The triple-zone JTE is promising for cost-effective fabrication of GaN power electronics.
20 October 2023 in e-Prime - Advances in Electrical Engineering, Electronics and Energy
7 October 2025 in IEEE Transactions on Microwave Theory and Techniques
High-gain GaN impact-ionization avalanche transit-time (IMPATT) diodes have been fabricated and experimentally characterized. The devices feature a “Hi-Lo” doping profile design; temperature-dependent reverse $I$ – $V$ measurement verified impact ionization avalanche as the dominant breakdown mechanism. IMPATT operation was confirmed, with reflection gain observed between 19.3 and 50.1 GHz using pulsed bias conditions of −175 V and current density of 7.6 kA/cm2. Apeak reflection gain of 1.97 dB was observed around 30.8 GHz. On-wafer S-parameter measurements revealed a large negative differential resistance (NDR) of $- 992~\Omega $ , comparable to state-of-the-art Si IMPATT diodes. The RF output power density is projected to be 40.3 kW/cm2 at 35 GHz. The short-pulse on-wafer S-parameter-based measurement technique used here facilitates direct extraction of device impedance, providing insights into the optimal impedance matching of the peripheral resonant circuit and the appropriate operating frequency. Temperature-dependent characterization shows that the avalanche frequency has a much stronger dependence on current density rather than bias voltage. Therefore, biasing with a current source is preferred compared to a voltage source for stable operation in applications. The maximum operating frequency is found to increase at higher temperatures, possibly due to a decrease in the series resistance associated with the anode’s p-contact resistance. These devices are promising for high-power, high-efficiency K-band to V-band signal generation across a broad temperature range.
4 November 2025 in APL Electronic Devices
We report the experimental characterization and theoretical analysis of high-frequency GaN IMPATT diodes featuring a Hi-Lo doping profile. On-wafer small-signal measurements of reflection gain over frequency and temperature confirm IMPATT operation covering Ka through V bands. Temperature-dependent reverse I–V measurements also confirmed avalanche breakdown as the dominant breakdown mechanism. Under a pulse bias of −175 V and current density of 7.6 kA/cm2, the fabricated IMPATT diode exhibited gain between 19.3 and 50.1 GHz, with peak gain of 1.97 dB at ∼30.8 GHz. Temperature dependent characterization revealed that while the bias voltage required for operation at a given frequency changes significantly with temperature, consistent and stable performance can be achieved using a current source for biasing. For a fixed current density, both the avalanche frequency and device impedance remained relatively stable over a broad ambient temperature range. For use as a free-running oscillator, the minimum required Q for the external resonator was found to be less than 3.6, which is well within the range of what can be achieved in practice at these frequencies. Theoretical predictions of avalanche frequency were conducted and showed good agreement with the measured avalanche frequency, facilitating precise design of oscillators for applications. The fabricated IMPATT diodes demonstrate significant potential for high-power and high-efficiency signal generation from K-band to V-band across a wide temperature range.