17 September 2018 in Journal of Mechanisms and Robotics
The assembly task is of major difficulty for manufacturing automation. Wherein the peg-in-hole problem represents a group of manipulation tasks that feature continuous motion control in both unconstrained and constrained environments, so that it requires extremely careful consideration to perform with robots. In this work, we adapt the ideas underlying the success of human to manipulation tasks, variable compliance and learning, for robotic assembly. Based on sensing the interaction between the peg and the hole, the proposed controller can switch the operation strategy between passive compliance and active regulation in continuous spaces, which outperforms the fixed compliance controllers. Experimental results show that the robot is able to learn a proper stiffness strategy along with the trajectory policy through trial and error. Further, this variable compliance policy proves robust to different initial states and it is able to generalize to more complex situation.
5 February 2018 in Assembly Automation
To paint large workpieces automatically, painting manipulators with hollow wrists must be transported by mobile platforms to different positions because of their limited workspaces. This paper aims to provide a visualization method for finding appropriate base positions (BPs) and maximum painting areas for manipulators. This paper begins by analyzing the motion characteristics of manipulators possessing a spherical wrist and summarizing them into three constraints – positioning, orientation and singularity avoidance. The hollow wrist is simplified and considered as spherical by introducing the concepts of an inner wrist center and an outer wrist center. Taking the three constraints into consideration, the boundaries of the manipulating space are formulated analytically. Finally, to verify the method, the space obtained is applied to determine the maximum painting areas for flat, cylindrical and conical surfaces. Experiments of robotic painting were used to confirm the results. Compared with previous studies, the maximum areas obtained using the proposed method increased by 17-131 per cent with an algorithm of lower complexity, and the process remained visually intuitive, thereby demonstrating that the method of manipulating space is more effective. Such a method allows individuals to visualize the entire painting area at the current BP, thereby maximizing painting areas or optimizing BPs. It opens a black box that is the relationship between BPs and blocks. The method can also be used to choose the best configuration for painting manipulators, select the end-effector structure parameters, split surfaces into blocks, etc.
1 January 2018 in International Journal of Robotics and Automation
In this paper, 7 revolutions with 6 degrees of freedom (7R 6-DOF) robots having non-spherical wrist are widely used in automatic coating of automobiles and aircrafts. These robots do not follow the Pieper rule; thus, a large amount of time is spent using numerical algorithms to calculate the inverse kinematic (IK) solutions. Therefore, this paper attempts to propose an efficient algorithm to reduce the calculation time for the IK solutions. Analogous to robots with spherical wrist, the concepts of "inner wrist centre' and "outer wrist centre" are put forward after a detailed analysis on the structure of 7R 6-DOF robots with non-spherical wrist. Considering the relationship between the outer and inner wrist centre, the position of the inner wrist centre is estimated and taken as the decoupling point to update the IK solutions analytically. Besides, some special cases affecting the efficiency of the algorithm are also discussed. Finally, the algorithm was implemented on computer to test the efficiency and applicability. According to experimental results, the algorithm can reduce time consumption by 30% in comparison with traditional algorithm, indicating that the proposed calculation algorithm is significantly effective.