1 September 2017 in Journal of Cleaner Production
MAMohamad Sahban Alnarabiji
Mohamad Sahban Alnarabiji
SASeyed Esmaeil Mahdavi Ardakani
Seyed Esmaeil Mahdavi Ardakani
+4
1 March 2017 in Materials Science and Engineering: B
6 January 2016 in Journal of Nano Research
NLNoor Rasyada Ahmad Latiff
Noor Rasyada Ahmad Latiff
+2
Due to the geographical location and technological limitation, various novel enhanced oil recovery (EOR) methods has been proposed to recover the remaining oil from a depleted oil reservoir. Research on application of nanoparticles either on its own or coupled with other stimulating agents has been growing enormously and some of them have shown a promising future. In high temperature and high pressure reservoirs, thermal degradation will cause failure to the conventional chemicals. In this work, temperature-stable YIG magnetic nanoparticles with an electromagnetic wave has been proposed as a new candidate for reservoir stimulating agent. The purpose of nanoparticle injection is to increase the sweep efficiency in the reservoir by increasing the viscosity of displacing fluid. In this research, Yttrium iron garnet (YIG) nanoparticles have been injected into a waterflooded oil saturated porous medium to recover the remaining oil in the presence of an electromagnetic wave. At the sintering temperature 1200°C, a mixture of hematite and YIG was obtained, suggesting a higher temperature for single phase YIG. From VSM analysis, the average magnetic saturation, coercivity and remanence are 18.17 emu/g, 21.73 Oe and 2.38 emu/g, respectively. 1.0 wt% of YIG nanofluid was prepared and subsequently injected into the pre-saturated porous medium in the presence of square electromagnetic wave of 13.6 MHz. As much as 43.64% of the remaining oil in place (ROIP) was recovered following the injection of 2 pore volume of YIG nanofluid.
1 April 2017 in Journal of Magnetism and Magnetic Materials
26 January 2020 in Journal of Taibah University for Science
In this study, scattering parameters of sandstone saturated with brine and nanofluids are evaluated experimentally and numerically for the application in enhanced oil recovery (EOR). Zinc Oxide (ZnO) and Bismuth ferrite BiFeO3 (BFO) nanoparticles were synthesized via facile sol–gel method followed by nanofluid preparation. Sandstone samples were saturated with brine and nanofluids for 48 h. Electromagnetic properties of the saturated sandstones were measured experimentally using the vector network analyzer, and the scattering parameters of the samples were studied numerically by finite element method. BFO displayed higher permeability value of 1.52 and 1.30, as well as superior dielectric permittivity value 11.55 and 6.59 for real and imaginary parts, respectively. In addition, the sandstone saturated with BFO showed an impressive reflection loss (RL) value of −9.77 dB at high frequency. Conclusively, BiFeO3 nanofluids showed the best potential to enhance oil recovery which can be accredited to the superior electromagnetic properties of BFO.
1 March 2011 in Journal of Nanoscience and Nanotechnology
RHRamadan Masoud Al Habashi
Ramadan Masoud Al Habashi
+1
Aluminum substituted yttrium iron garnet nano particles with compositional variation of Y3.0−x Al x Fe5O12, where x = 0.0, 0.5, 1.0, 1.5, 2.0, 2.5 and 3.0 were prepared using sol gel technique. The X-ray diffraction results showed that the best garnet phase appeared when the sintering temperature was 800 °C. Nano-crystalline particles with high purity and sizes ranging from 20 to 100 nm were obtained. It was found that the aluminum substitution had resulted in a sharp fall of the d-spacing when x = 2, which we speculated is due to the preference of the aluminum atoms to the smaller tetrahedron and octahedron sites instead of the much larger dodecahedron site. High resolution transmission electron microscope (HRTEM) and electron diffraction (ED) patterns showed single crystal nanoparticles were obtained from this method. The magnetic measurement gave moderate values of initial permeability; the highest value of 5.3 was shown by sample Y3Fe5O12 at more than 100 MHz which was attributed to the morphology of the microstructure which appeared to be homogeneous. This had resulted in an easy movement of domain walls. The substitution of aluminum for yttrium is speculated to cause a cubic to rhombodedral structural change and had weakened the super-exchange interactions thus a fall of real permeability was observed. This might have created a strain in the sub-lattices and had subsequently caused a shift of resonance frequencies to more than 1.8 GHz when x > 0.5.