1 October 2014 in Advanced Materials Research
A development of fiber-cement composites is often focused on cost-effective and environmentally friendly materials (so-called green materials). Production of this material should produce less waste and it also should use less energy and less natural sources. There are numerous approaches to the development of green composites. One of the possible ways is a utilization of fly ashes instead of the cement part of composite. The paper discusses a development of green cementitious composite which incorporated fly ash materials produced in the Moravian-Silesian region as a partial replacement of the cement part of the composite.
17 April 2014 in Advanced Materials Research
In recent years numerous advanced materials technologies have appeared in the market or have been developed for use in construction. In civil engineering there are also numerous fields of application for these materials, which can be used for construction of new buildings as well as for reparation and improvement of older structures. In many cases the helical reinforcement is used for the improvement and rehabilitation of masonry structures. This type of reinforcement offers several advantages. It requires only minimal changes of the existing masonry elements and it introduces no visual changes of the rehabilitated structure. In the paper a numerical analysis and an assessment are presented of such a helical reinforcement for the improvement of axially loaded masonry columns.
19 June 2019 in Solid State Phenomena
This paper deals with analysis of set of reinforced concrete beams. Loading experiments of these beams were carried out and the results were documented and published earlier. Experiments involve several variants of spans, cross-sections and reinforcement so that various modes of failure of reinforced concrete structures are achieved. This paper compares the resistance of particular beams defined according to valid standard Eurocode 2 with non-linear analysis using advanced spatial 3D numerical models Cementitious material model based on fracture mechanics implemented in ATENA software. This paper outlines the wider evaluation of failure mode of beam and comparison of different calculations of resistance of the cross-section.
13 December 2013 in Applied Mechanics and Materials
The contribution compares the response of envelope of chosen structure to the effects of transient load. The load was caused by air blast wave due to deflagration of methane-air mixture. The paper deals with interaction of incident blast wave and envelope structure. Considering blast courses obtained from experiments, two simplified models of load were developed. Load, defined by both load functions, was applied to 3D numerical model of the structure. Calculated result values of deflections of wall elements were compared to experimentally obtained deflections.
1 October 2014 in Advanced Materials Research
The paper discusses selected aspects on numerical modelling of historical masonry structures. Linear elastic material models are mentioned first, and then non-linear models are discussed. The paper includes several examples of solutions which have been done with use of these models. There is also an example of results which can be obtained from anon-linear analysis of masonry structures. The finite element method is used for computations.