6 July 2012 in IEEE Transactions on Industrial Electronics
In computerized numerical control (CNC) systems, the communication bus between the controller and axis servo drives must offer high bandwidth, noise immunity, and time determinism. More and more CNC systems use real-time Ethernet protocols such as Ethernet Powerlink (EPL). Many modern controllers are closed costly hardware-based solutions. In this paper, the implementation of EPL communication bus in a PC-based CNC system is presented. The CNC system includes a PC, a software CNC controller running under Linux Real-Time Application Interface real-time operating system and servo drives communicating via EPL. The EPL stack was implemented as a real-time kernel module. Due to software-only implementation, this system is a cost-effective solution for a broad range of applications in machine control. All software systems are based on GNU General Public License or Berkeley Software Distribution licenses. Necessary modifications to the EPL stack, Linux configurations, computer basic input/output system, and motherboard configurations were presented. Experimental results of EPL communication cycle jitter on three different PCs were presented. The results confirm good performance of the presented system.
1 February 2022 in IEEE Transactions on Industrial Informatics
In this article, a NURBS toolpath feedrate profile generation algorithm for a biaxial linear motor control system is presented. High achievable velocities and accelerations of linear motor machines present new computational challenges in implementing feedrate generation and toolpath interpolation algorithms in real-time controllers. The proposed algorithm is capable of online generation of the feedrate profile with axial acceleration and jerk constraints. Each stage of the feedrate profiling algorithm is described with attention being given to both performance and implementation aspects. Furthermore, an alternative to the commonly used Taylor series interpolation method is also tested to ensure minimal interpolation errors. The feedrate profiling and interpolation algorithms’ implementation in a PC-based controller with real-time Linux kernel is described. Experimental results are presented that confirm that the algorithm is capable of limiting acceleration and jerk in the machine’s axes and it is low computation time enables real-time on-line operation in a PC-based CNC controller.
1 September 2014 in Bulletin Of The Polish Academy Of Sciences-Technical Sciences
This paper presents the design and analysis process of state feedback controllers for NPC type 3-level sine wave inverter. In order to achieve good dynamic features in a state feedback control an internal model of reference input and a feedforward path are introduced. During synthesis process of the state feedback controllers maximum permissible dynamics of voltage control in the linear range of modulation is taken into account. It is shown that initially gains of the controller and feedforward path are non-stationary and depend on the angular velocity. Stationary approximation of a non-stationary state feedback controller is presented in details. Proposed state feedback control structures for continuous voltage shaping NPC type 3-level voltage source inverter are examined in FOC PMSM drive. The novelty of the presented controller lays in a stationary approximated state feedback control structure designed in terms of maximum permissible dynamics of a voltage control system. Simulation and experimental results (at the level of 3 kW) of the designed control algorithms are included.