7 December 2023 in Physical Review Research
Electronic resonances can significantly enhance photon-phonon coupling but are normally avoided in cavity optomechanics due to absorption losses and dephasing by inhomogeneous broadening. We demonstrate experimentally that exciton-polaritons in semiconductor microcavities enable single-particle resonant optomechanical couplings with GHz vibrations reaching record values in the tens of MHz range. Moreover, this resonant enhancement is protected from inhomogeneous broadening by the Rabi gap. Single-polariton nonlinearities and the optomechanical strong-coupling regime become accessible in this platform.
6 December 2019 in IEEE Transactions on Terahertz Science and Technology
We have developed terahertz (THz) quantum-cascade lasers (QCLs) based on GaAs/AlAs heterostructures for application-defined emission frequencies between 3.4 and 5.0 THz. Due to their narrow line width and rather large intrinsic tuning range, these THz QCLs can be used as local oscillators in airborne or satellite-based astronomical instruments or as radiation sources for high-resolution absorption spectroscopy, which is expected to allow for a quantitative determination of the density of atoms and ions in plasma processes. The GaAs/AlAs THz QCLs can be operated in mechanical cryocoolers and even in miniature cryocoolers due to the comparatively high wall-plug efficiency of around 0.2% and typical current densities below 500 A/cm $^2$ . These lasers emit output powers of more than 1 mW at operating temperatures up to about 70 K, which is sufficient for most of the abovementioned applications.
26 May 2022 in Physical Review B
Two-photon coherent states are one of the main building pillars of nonlinear and quantum optics. They are the basis for the generation of minimum-uncertainty quantum states and entangled photon pairs, applications not obtainable from standard coherent states or one-photon lasers. Here, we describe a fully resonant optomechanical parametric amplifier involving a polariton condensate in a trap lattice quadratically coupled to mechanical modes. The quadratic coupling derives from nonresonant virtual transitions to extended discrete excited states induced by the optomechanical coupling. Nonresonant continuous-wave laser excitation leads to striking experimental consequences, including the emergence of optomechanically induced intersite parametric oscillations and intersite tunneling of polaritons at discrete intertrap detunings corresponding to sums of energies of the two involved mechanical oscillations (20- and 60-GHz confined vibrations). We show that the coherent mechanical oscillations correspond to parametric resonances with a threshold condition different from that of standard linear optomechanical self-oscillation. The associated Arnold tongues display a complex scenario of states within the instability region. The observed phenomena can have applications for the generation of entangled phonon pairs and squeezed mechanical states relevant in sensing and quantum computation and for the bidirectional frequency conversion of signals in a technologically relevant range.
7 February 2024 in IEEE Transactions on Terahertz Science and Technology
The oxygen spectrometer for atmospheric science on a balloon (OSAS-B) is the first 4.7-THz heterodyne spectrometer on a stratospheric balloon. It has been developed for remote sensing of the 4.7-THz emission of neutral atomic oxygen in the mesosphere and lower thermosphere of the Earth. OSAS-B comprises a heterodyne receiver based on a hot-electron bolometer mixer and a quantum-cascade laser as local oscillator. The high sensitivity of the superconducting detector and the large resolving power of approximately 1×10 7 enable the detection of subtle signatures of radiation transport and high-altitude winds in the measured spectra. The first flight of the instrument took place on September 7th, 2022 from Esrange, Sweden.
7 February 2022 in Physical Review Applied
The determination of the carrier diffusion length of semiconductors such as and by cathodoluminescence imaging requires accurate knowledge about the spatial distribution of generated carriers. To obtain the lateral distribution of generated carriers for sample temperatures between 10 and 300 K, we utilize cathodoluminescence intensity profiles measured across single quantum wells embedded in thick and layers. Thin (,) and (,) barriers respectively prevent carriers diffusing in the and layers to reach the well, which would broaden the profiles. The experimental cathodoluminescence profiles are found to be systematically wider than the energy loss distributions calculated by means of the Monte Carlo program casino, with the width monotonically increasing with decreasing temperature. This effect is observed for both and and becomes more pronounced for higher acceleration voltages. We discuss this phenomenon in terms of both the electron-phonon interaction controlling the energy relaxation of hot carriers and the shape of the initial carrier distribution. Finally, we present a phenomenological approach to simulate the carrier generation volume that can be used for the investigation of the temperature dependence of carrier diffusion.
17 June 2024 in IEEE Transactions on Terahertz Science and Technology
We report on the development and the application of high-performance terahertz (THz) quantum-cascade lasers (QCLs) based on GaAs/Al $_{x}$ Ga $_{1-x}$ As heterostructures. These lasers with emission frequencies between 2.6 and 4.7 THz are based on a hybrid design, which is preferred for continuous-wave applications. For the design of the active regions, we employ an efficient Fourier-transform-based model which also allows for the simulation of heterostructures with gradual interfaces. Since the inherent interface width is on the same order as the thickness of the layers in the active region, the use of nominally binary AlAs barriers results in an effective Al content up to $x$ $=$ 0.6 for the tallest barriers. For practical applications, Fabry-Pérot lasers based on single-plasmon waveguides are fabricated. Single-mode operation is in most cases achieved by using short cavities. In particular, GaAs/AlAs THz QCLs show a sufficiently high wall plug efficiency so that they can be operated in miniature mechanical cryocoolers. Currently, high-performance THz QCLs are used for commercial continuous-wave, table-top THz systems, local oscillators in 3.5- and 4.7-THz heterodyne spectrometers, and absorption spectrometers for the determination of the density of atomic oxygen in plasmas.