14 September 2026 in Materials Science and Engineering: A
24 June 2026 in SSRN Electronic Journal
This study investigates elastic anisotropy in thick-walled 316LSi stainless steel deposits fabricated by Wire Arc Additive Manufacturing (WAAM). Four deposition conditions were evaluated by varying heat input (10 and 15 kJ/in.) and interpass temperature (121 and 399 °C), while maintaining a consistent alternating parallel toolpath strategy with 45% bead overlap. Optical metallography revealed that this tool path promoted cyclic partial remelting and produced a distinct periodic, wavy columnar grain morphology. Electron Backscatter Diffraction (EBSD) indicated corresponding crystallographic texture tendencies, with ⟨100⟩ alignment along the deposition direction (X-axis) and ⟨111⟩ alignment along the transverse direction (Y-axis). Since ⟨111⟩ is the stiffest and ⟨100⟩ is the most compliant crystallographic direction in FCC 316L/316LSi, these texture tendencies provide a mechanistic basis for the observed macroscopic elastic anisotropy. Room-temperature tensile testing and resonant frequency and damping analysis (RFDA) from 23 °C to 400 °C confirmed a consistent orientation-dependent modulus hierarchy of EY > EZ > EX. The lowest Young’s modulus values were consistently measured along the deposition direction (X-axis: 146 to 150 GPa), while the highest values were observed along the transverse direction (Y-axis: 187 to 197 GPa). Overall, elastic anisotropy was governed primarily by the toolpath-induced microstructure and crystallographic texture, rather than by variations in heat input or interpass temperature within the processing window studied. The modulus hierarchy also persisted up to 400 °C, indicating stable anisotropic elastic behavior under the tested thermal exposure conditions.
29 September 2026 in Results in Engineering