An all-fiber low-repetition-rate SESAM mode-locked fiber oscillator combined with a dispersion-managed active fiber loop produces a flexible GHz burst-mode laser source. The high-power output is then produced by amplifying the GHz burst-mode laser source using an all-fiber chirped-pulse amplification system. Then, the laser is compressed using a grating pair compressor; a maximum amplified power of 97 W is obtained. This results in a compressed high power of 82.07 W with a power stability RMS of 0.09% and beam quality better than 1.2. Accurate dispersion control allows for the production of a high-quality pulse duration of 265 fs.
6 September 2023 in Journal of Lightwave Technology
A hybrid chirped pulse amplification system composed by the monolithic fiber pre-amplifier and a two-stage single-pass single crystal fiber amplifier was demonstrated. A maximum power of 68 W at the repetition rate of 100 kHz was obtained. The laser pulses were amplified and then compressed using a 1600 line/mm grating pair compressor. A short pulse duration of 358 fs and a power of 54 W were obtained at 100 kHz, corresponding to a peak power of 1.508 GW, to the best of our knowledge, this is the highest peak power ever obtained from single crystal fiber at repetition rate above 100 kHz due to the consideration of the third order dispersion which was engraved in the stretcher and the tuning capacity of higher-order dispersion compensation of chirped fiber Bragg grating. Additionally, the beam quality better than 1.3 was obtained. This high peak power CPA system with excellent comprehensive parameters will find various applications in scientific research and industrial applications.
21 March 2024 in Microwave and Optical Technology Letters
A monolithic all-fiber high-energy chirped pulse amplification (CPA) system with a managed large dispersion is demonstrated. To lower the system’s nonlinearity, two temperature-tuning cascaded chirped fiber Bragg gratings (CFBGs) with a large dispersion of 200 ps/nm are used as the stretcher to stretch the pulse duration to more than 2 ns in the time domain. The main amplifier, a short-length silicate glass fiber with a large mode area and a high gain, increases the energy to 293 μJ at 100 kHz. To compress the large-dispersion chirped pulse into a compact structure, a reflective grating pair with a high density of 1740 lines/mm is used as the compressor. Owing to the high-order dispersion pre-compensation by the CFBGs and the large-sized grating with high diffraction efficiency, a compressed pulse duration of 466 fs with a pulse energy of 250 μJ is obtained, corresponding to a compression efficiency of more than 85%. The well-preserved beam quality with measured M2 value is better than 1.3. To best of our knowledge, this is the highest pulse energy ever achieved in a monolithic fiber femtosecond laser system.