Sodium carboxymethylcellulose (CMC-Na) microparticles, containing corrosion inhibitor benzotriazole (BTA), were prepared using different spray drying processing parameters, with the purpose of future application in protective coatings for the delivery of corrosion inhibitors. The effects of the processing parameters, such as inlet temperature and spray flow rate, are discussed herein. The biopolymeric CMC-Na microparticles obtained were characterized morphologically by SEM and TEM, and their release profile studied by UV-Vis. The results show that the prepared microparticles (microspheres) were homogeneous, spherically shaped and of a matrix-type nature. Additionally, it was observed that the inlet temperature and spray flow rate significantly influenced the release profiles and process yields. From the different process parameters tested, it was found that the best conditions to achieve higher process yields, higher encapsulation efficiencies and better release properties, were an inlet temperature of 170 °C, a pump rate of 2.5 mL/min, and a drying air-flow rate of 440 L/h.
This work describes a composite electrode based on carbon black (CB) and poly(ethylene-co-vinyl)acetate (EVA) for development of a robust, low cost and time-saving method for the amperometric determination of hydrochlorothiazide (HCTZ) in a pharmaceutical formulation and synthetic human urine samples. This composite electrode exhibits favourable features such as mechanical resistance, low cost and simple preparation. The proposed electrode was used as an amperometric detector in flow injection analysis (FIA) based on HCTZ oxidation. The best amperometric responses were obtained by employing a composite electrode made with 75% (w/w) carbon black (CB) and 25% (w/w) poly(ethylene-co-vinyl)acetate (EVA), sample volume of 100 μL, flow rate of 5.3 mL min−1 and potential of detection of +900 mV vs. Ag/AgCl/3.0 mol L−1. Under optimized conditions, it was possible to achieve an analytical frequency of 128 injections h−1, a linear dynamic range (LDR) of 10 to 200 μmol L−1, a limit of quantification (LOQ) of 4.4 μmol L−1 and a limit of detection (LOD) of 1.3 μmol L−1 for HCTZ. The proposed method was successfully applied for determination of HCTZ in commercial tablets and synthetic human urine samples without any chemical pretreatment. The composite electrode based on EVA and carbon black is feasible and totally adaptable to portable devices for HCTZ quantification.