We study the relative intensity noise (RIN) and timing jitter of a Raman soliton. We demonstrate that the RIN of an excitation pulse causes center–wavelength fluctuations of the resulting Raman soliton which translates by fiber dispersion into relative timing jitter (RTJ) between the Raman soliton and the excitation pulse. The Raman soliton’s absolute timing jitter is dominated by the excitation pulse’s timing jitter at low frequency and by the RTJ at high frequency. The experimental study reveals that RTJ can be significantly reduced by reducing the accumulated fiber dispersion (e.g., using less dispersive fibers with shorter length) experienced by the Raman soliton.
We demonstrate a high-power offset-free ultrafast mid-infrared (IR) laser source based on difference-frequency generation (DFG). Powerful signal pulses are obtained by filtering the rightmost spectral lobe of the optical spectra broadened by fiber-optic nonlinearities dominated by self-phase modulation. The resulting mid-IR pulses are tunable from 7 to 18 μm with up to 5.4 mW average power. We experimentally and numerically investigate power scaling of this DFG source and demonstrate that increasing the signal power is an efficient approach for generating high-power mid-IR pulses.
We demonstrate both numerically and experimentally that self-phase modulation-enabled spectral selection generates wavelength tunable energetic pulses that are tightly synchronized to the excitation pulses. The synchronization quantified by relative timing jitter is at the 100-as precision level, at least 10 times lower than can be achieved by Raman soliton pulses derived from the same source laser. This ultrafast two-color source is suitable for many important applications that require tight pulse synchronization.
In this submission, we report a maximum 638-W fiberized chirped-pulse-amplification (CPA) laser system with a bulk reflection grating compressor. The system is able to emit 338-W compressed pulses of 624 fs centered at 1 µm, corresponding to a pulse energy of 1.3 µJ at a pulse repetition rate of 258 MHz. The output beam quality factor M 2 is measured to be <1.3, without observing transverse-mode instability. The standard deviation of the power fluctuation is quantified to be 0.6 W over a time span of more than 1 hour, at an output power of up to 100 W.