11 November 2019 in IEEE Access
For the design of printed circuit board (PCB) winding, it is necessary to take into account the requirements of electromagnetic and manufacture technology of PCB winding, which directly affect the output power of the machine. In this paper, for axial flux permanent magnet generator (AFPMG) of a small wind power system, the unequal-width (UEW) winding is proposed for the aim of improving the output power of the generator. The design ideas and methods of unequal-width (UEW) winding are proposed in combination with manufacture technology of the PCB. The finite element analysis (FEA) model of machine is built. The analytical formulas of electromotive force (EMF) and winding loss are derived. Though the comparisons between reactance and impedance of PCB winding, the analytical formula of output power is simplified. These characteristics of the generator with traditional equal-width(EW) winding and proposed UEW winding are analyzed and compared in detail by FEA and analytical calculation. The result shows that the output power of the generator with UEW winding is improved largely. Finally, the validity of the FEA model and analysis method is verified by experiment of prototype machine, which provides the reference for the design of AFPMG with PCB winding.
26 June 2017 in Applied Physics Letters
This paper reports an uncooled infrared (IR) detector based on a micromachined piezoelectric resonator operating in resonant and resistive dual-modes. The two sensing modes achieved IR responsivities of 2.5 Hz/nW and 900 μdB/nW, respectively. Compared with the single mode operation, the dual-mode measurement improves the limit of detection by two orders of magnitude and meanwhile maintains high linearity and responsivity in a higher IR intensity range. A combination of the two sensing modes compensates for its own shortcomings and provides a much larger dynamic range, and thus, a wider application field of the proposed detector is realized.
7 July 2014 in Applied Physics Letters
In this paper, we present a single-plate electro-wetting on dielectric (SEWOD) device by integrating an island-ground electrode (IG), which is surrounded by the driving electrodes and looks like an island. Both experiments and theoretical analysis have been conducted to investigate the performance of the IG-SEWOD device. The driving voltage of a fabricated IG-SEWOD has been measured to be 15 V, which is half of that of a floating SEWOD. The digital dynamic properties of the EWOD device are greatly enhanced due to the “double locking” effect and rapid residual charges elimination provided by the IG. The proposed EWOD device shows great potential in constructing advanced microfluidics platforms for bio-chemical detection and disease diagnosis.
17 January 2011 in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
In this paper, micromachined longitudinal wave resonant mass sensors operating near 1 GHz in a liquid environment are investigated and characterized. Mass sensitivities of the film bulk acoustic resonator (FBAR) and high-tone bulk acoustic resonator (HBAR) microbalances with small size are measured to be 782.7 cm2/g (50 times larger than that of conventional bulky quartz crystal microbalance) and 9.3 cm2/g, respectively. Based on the mass sensitivities and frequency noise floor, the minimum detectable mass of the FBAR and HBAR are estimated to be 2.8 ng/cm2 and 11.9 ng/cm2 in liquid, respectively.