27 July 2020 in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
Based on three groups of different offset voltages, a bandgap reference (BGR) and power-ON reset (POR) hybrid circuit is implemented in 65-nm CMOS. The BGR using amplifier offset voltage and current matching, and the POR using offset voltage comparison and loop settling feature, respectively, are proposed. This circuit, with low-quiescent current, not only generates a stable reference voltage independent of voltage and temperature variations, but also provides a high-robust supply-ramp-rate-tolerant power-ON/brown-out reset signal with a hysteretic window of 18-24 mV. Experimental results show that the circuit with line regulations (LNRs) of 2.63%-4.28%/V and temperature coefficients (TCs) of 22-32 ppm/°C across multiple chips has a power dissipation around 2.25 μW from a 1-V supply voltage. The circuit achieves a low noise density of 18.5 nV/√ Hz at 100-Hz offset frequency and a good figure of merit (FoM) performance. With an active core area of 0.014 mm², the circuit has fixed reset trip voltages under the supply ramp time of 0.4-100 ms.
2 March 2022 in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
A 1.15-mW 3.75–4.25-GHz frequency-modulated ultrawideband (FM-UWB) transmitter (TX) is fabricated in 65-nm CMOS, with digitally reconfigurable subcarrier frequencies, UWB bandwidth, and radio frequency (RF) frequency band. Low-complexity submodules are utilized with significant power savings. An ultralow-current hybrid module is for bandgap reference (BGR) and power-ON reset (POR), and a single-ended crystal oscillator (XO) generates a 12-MHz clock reference. A dual-path ring voltage-controlled oscillator (VCO) conducts linear RF FM, followed by a push–pull power amplifier (PA) for 100-kb/s wireless data transmission. A differential relaxation oscillator (OSC) is for subcarrier generation, and an intermittent dual-mode frequency calibration loop ensures system robustness. Experimental results show that the presented FM-UWB TX successfully generates an Federal Communications Commission (FCC)-compliant UWB signal, with an energy efficiency of 11.5 nJ/bit and an active area of 0.21 mm 2 from a 1-V supply. The 2.25- $\mu \text{A}$ hybrid BGR and POR achieves a temperature coefficient of 32 ppm/°C, a line regulation of 2.3%/V, a supply-ramp-rate-tolerant power-ON, and brown-out function. The 40- $\mu \text{W}$ XO features a low-frequency inaccuracy of 4 ppm/V. The 40- $\mu \text{A}$ relaxation OSC provides the reconfigured two-frequency shift keying (FSK) triangular amplitude and frequency. The 2.79–5.18-GHz 0.6-mW ring VCO is capable of providing the phase noise performance of −77 dBc/Hz at the 1-MHz offset, followed by the 0.45-mW PA having the output power higher than −14 dBm and the peak power-added efficiency (PAE) of 29.6%. All these benefit low-power low-cost TX implementation, where the carrier and subcarrier frequencies are calibrated by an intermittent digital loop with omitted power dissipation.