In this work, a method of regenerative braking of an electric scooter was developed. Regenerative braking of electric vehicles is the basis for energy saving cars and environmental protection. A stand was made for the study of a magnets and an ionistor. In the proposed method, an ionistor is additionally connected in parallel to the battery, which charges faster than the battery, so the process of accelerating the electric vehicle after stopping also occurs faster. It should also be noted that if emergency braking is necessary to stop an electric vehicle, the driver can press the brake pedal and stop the car using brake pads. The paper investigates the method of the element base for the vehicle, as well as control. To develop this study, an electric scooter was chosen as an electric vehicle model. The dependences of the electric current on the operating time of the ionistor in three positions are determined. During the actual speed of the electric scooter corresponds to the controlled speed.
We present new experimental data for the inclusive (p,xp) and (p,x $$\alpha $$ ) reactions on $$ ^{27}$$ Al target. Double-differential cross sections of (p,xp) at energies 7, 22, 30 MeV and (p,x $$\alpha $$ ) at energies 22, 30 MeV within the angular range of 30 $$ ^{\circ }$$ –135 $$ ^{\circ }$$ have been measured for the first time. The data has been analyzed by using the exciton model, along with multistep direct and multistep compound models to evaluate the adequacy of the theoretical models in explaining the measured data. Our calculations indicate that the exciton model captures the general trends and oscillatory structures of the spectra at higher proton energies; however, the agreement between theory and experiment remains qualitative, reflecting the inherent complexity of pre-equilibrium reaction mechanisms.
1 January 2024 in Physical Sciences and Technology
The multichannel analyzer (MCA) is a crucial device for recording and analyzing radiation energy spectra to ascertain energy and intensity. It can be implemented via FPGA with a fast ADC and digital algorithm or a microcontroller with a peak detector circuit using an analog electrical circuit. MCA is widely applied in field work, nuclear medicine, and accelerator experiments. This work focuses on developing a lowcost alpha and gamma spectrometric system for experimental physics and field work, such as recording radiation and monitoring nuclear facility surroundings. Modern microcircuits, with small size and low power consumption, enable simpler and cheaper analog signal processing circuits that process signals in real-time without digital conversion delays. The spectrometric amplifier (SA) and peak detector (PD) were modeled and prototyped. A Python-based real-time data acquisition program was developed. Signals are recorded on the STM32F407 microcontroller’s ADC and transmitted via USB to a PC. An experiment obtaining the Ra226 alpha source spectrum verified the MCA’s functionality. It is valuable for environmental radioactivity field work and student teaching.
We present the design and implementation of a compact digital data acquisition system based on the STM32F407 microcontroller for use in charged-particle spectroscopy. The system digitizes signals from a two-detector telescope (Δ E-E ) and transfers the results to a PC in real time via USB. The approach combines an analog front-end (preamplifier, CR-RC shaper, comparator, and peak detector) with microcontroller-based digitization and data transfer. This setup allows construction of two-dimensional coincidence matrices (Δ E vs. E ) for particle identification.
1 June 2026 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment