5 October 2021 in IEEE Transactions on Electron Devices
Nitrogenous octadecylamine (ODA) self-assembled multilayers (SAMs) are prepared as passivation layers by the vapor-phase process for amorphous InSnZnO (ITZO) thin-film transistors (TFTs). The vapor-phase proposed ODA SAMs show excellent properties as a barrier against the atmosphere and serve as an effective nitrogen doping (N doping) source. After the self-assembled process, the distribution of the oxygen vacancies is modified by N-doping in the channel of the ITZO TFTs, wherefore the ITZO TFTs with ODA SAMs demonstrate an improvement of electrical properties. In addition, the oxygen and water adsorption/desorption reactions at the back channel are suppressed by the atmosphere isolation and N-doping effect, leading to an improvement of the positive bias stability. These results indicate that the nitrogenous ODA SAMs can be likely passivation layers for high-performance oxide TFT devices.
13 January 2025 in IEEE Electron Device Letters
The development of bio-based synaptic transistors faces significant challenges. These arise from conflicting requirements between the hydrophilic ion interface and the polar nature needed for the channel interface. To address this, we introduced modification layers between the channel and bio-based pectin. Specifically, we employed a method that simultaneously regulates hydrophobicity and polarity, thereby optimizing the electron-ion coupling interface. Through a comprehensive analysis of interface polarity and surface energy characteristics, we identified poly(methyl methacrylate) (PMMA) as the optimal modification material. PMMA not only enhances proton permeation but also significantly improves electron transport. Consequently, synaptic transistors incorporating PMMA modification layers demonstrated a marked increase in post-synaptic response intensity. Furthermore, these devices successfully replicated a wide range of complex synaptic functions, including applications such as image display with low-frequency suppression and enhanced contouring. In addition to its performance-enhancing properties, the PMMA modification layer serves as a protective shield, ensuring stable synaptic signal output under mechanical bending conditions for over 10 4 cycles. It also can maintain functionality throughout the cyclic degradation and replacement of ion interfaces. This research offers exciting potential for advancements in biocompatible and reusable electronics.
18 November 2021 in IEEE Transactions on Electron Devices
Self-assembled monolayers (SAMs) with three different head functional groups are prepared as passivation layers (PVLs) for amorphous InSnZnO (ITZO) thin-film transistors (TFTs). Head groups exhibit considerable modulation of surface topography and surface energy, leading to a difference in the passivation effect. This variation is attributed to the discrepancy of the binding methods determined by the head groups. Additionally, the head groups also modulate the relative direction and strength properties of dipoles at ITZO surface, which affects the surface potential and carrier density in ITZO films. As a consequence, the electric performance and stability of devices can be modulated by head groups in SAMs. These results provide a likely and low-cost method to ameliorate the capability of TFTs.
8 January 2024 in Applied Physics Letters
Low-frequency noise (LFN) in InSnZnO (ITZO) thin-film-transistors (TFT) with high-quality SiO2 gate oxide (GO) stacks is studied. This stack is fabricated by the plasma enhanced chemical vapor deposition (PECVD) and comprises two single layers. One layer is deposited by a SiH4 source (SiH4–SiO2), and the other uses a tetraethyl-orthosilicate precursor (TEOS-SiO2). The drain current noise power spectral densities follow the typical 1/f rule, and the main origin of LFN changes with the variation of drain current intensities. At low drain current intensities, LFN is affected by grain boundaries in the channel. As the drain current intensities increase, LFN originates from the carrier number fluctuations in devices with single TEOS-SiO2 GOs and from the carrier number with correlated mobility fluctuations in devices with SiO2 stacks GOs. At extremely high drain current intensities, the contact noise acts as a significant source of LFN in devices with SiO2 GO stacks. According to the carrier number with correlated mobility fluctuation (ΔN−Δμ) model, the devices with optimal stacks GOs exhibit a relatively low trap density near the ITZO/SiO2 interface. Additionally, these devices have a lower border trap density in GOs compared to those with single compositions. It demonstrates that high-quality SiO2 stacks reduce traps near the SiO2/ITZO interface, leading to enhanced devices performance. This work provides a precise and efficient method to evaluate the quality of GOs in metal oxide TFTs.
22 April 2024 in Applied Physics Letters
Source–drain contacts seriously affect low frequency noise (LFN) in amorphous IZO (a-IZO) thin-film transistors with bilayer ITO/Mo electrodes at cryogenic temperatures. In the range of 7–300 K, electrical and LFN performances of devices are measured, and the temperature dependence of channel resistances (Rch) and contact resistances (Rsd) is also analyzed. The carrier transport transition both occurs in a-IZO channels at 80 K and in ITO/Mo electrodes at 100 K, which causes the variation in Rsd and Rch. Below 80 K, the variable range hopping conduction dominates in the channels and contacts with Rsd/Rch ratio > 1. The LFN measured results indicate that the noise is contact-dominated. At higher temperatures above 120 K, the band conduction dominates in the channel, with Rsd/Rch ratio < 1, and the noise is channel-dominated. The main mechanism of noise transfers from the mobility fluctuation to the carrier number fluctuation. We consider that the contribution of contact noise to total LFN is determined by the Rsd/Rch ratio. This work provides comments for the selection of electrode materials in devices applied to cryogenic integration circuits.
18 November 2021 in Ferroelectrics
In this paper, Co-doped Na3V2−xCox(PO4)2F3(x = 0,0.1,0.5,0.7) sodium ion battery anode material was prepared by one-step hydrothermal method, and Na3V1.5Co0.5(PO4)2F3 anode material coated with graphene was also prepared. It is confirmed that moderate Co2+ doping can improve the electrochemical performance of NVPF. Among all samples, Na3V1.5Co0.5(PO4)2F3@Graphene shows the best rate and cycle performance. It exhibits the highest specific capacity of 91.5 and 48.8 mAh/g at 1C, respectively when x = 0.5, after coating graphene, the charge-discharge specific capacities of 1C cycle are 128.2 mAh/g and 63.5 mAh/g for the first time, and 62.2 mAh/g and 45.1 mAh/g for 45 weeks.The performance results show that the excellent electrochemical performance of Na3V1.5Co0.5(PO4)2F3@Graphene can be attributed to the increase in electronic conductivity and ion diffusion coefficient.