1 September 2019 in Materials Science and Engineering: C
CPCristiane Patricia Pissinato Pere
Cristiane Patricia Pissinato Pere
+1
1 March 2019 in Materials & Design
15 May 2019 in Journal of The Royal Society Interface
The antennae of mosquitoes are model systems for acoustic sensation, in that they obey general principles for sound detection, using both active feedback mechanisms and passive structural adaptations. However, the biomechanical aspect of the antennal structure is much less understood than the mechano-electrical transduction. Using confocal laser scanning microscopy, we measured the fluorescent properties of the antennae of two species of mosquito—Toxorhynchites brevipalpisandAnopheles arabiensis—and, noting that fluorescence is correlated with material stiffness, we found that the structure of the antenna is not a simple beam of homogeneous material, but is in fact a rather more complex structure with spatially distributed discrete changes in material properties. These present as bands or rings of different material in each subunit of the antenna, which repeat along its length. While these structures may simply be required for structural robustness of the antennae, we found that in FEM simulation, these banded structures can strongly affect the resonant frequencies of cantilever-beam systems, and therefore taken together our results suggest that modulating the material properties along the length of the antenna could constitute an additional mechanism for resonant tuning in these species.
11 December 2020 in Soft Matter
A method for predicting the solidification and stress of a digital light processing 3D print process is presented, using a voxel-based, multi-layer model to predict the degree of polymerization of the material at every stage during the print.
27 April 2010 in Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science
This article describes a surgical robotic device that is able to discriminate tissue interfaces and other controlling parameters ahead of the drill tip. The advantage in such a surgery is that the tissues at the interfaces can be preserved. A smart tool detects ahead of the tool point and is able to control the interaction with respect to the flexing tissue, to avoid penetration or to control the extent of protrusion with respect to the position of the tissue. For surgical procedures, where precision is required, the tool offers significant benefit. To interpret the drilling conditions and the conditions leading up to breakthrough at a tissue interface, a sensing scheme is used that discriminates between the variety of conditions posed in the drilling environment. The result is a fully autonomous system, which is able to respond to the tissue type, behaviour, and deflection in real-time. The system is also robust in terms of disturbances encountered in the operating theatre. The device is pragmatic. It is intuitive to use, efficient to set up, and uses standard drill bits. The micro-drill, which has been used to prepare cochleostomies in the theatre, was used to remove the bone tissue leaving the endosteal membrane intact. This has enabled the preservation of sterility and the drilling debris to be removed prior to the insertion of the electrode. It is expected that this technique will promote the preservation of hearing and reduce the possibility of complications. The article describes the device (including simulated drill progress and hardware set-up) and the stages leading up to its use in the theatre.
1 December 2018 in Current Opinion in Insect Science
Micro-Electro MechanicalSystem(MEMS) microphones inspired by the remarkable phonotactic capability of Ormia ochracea offer the promise of microscale directional microphones with a greatly reduced need for post-processing of signals. Gravid O. ochracea females can locate their host cricket's 5 kHz mating calls to an accuracy of less than 2 degrees despite having a distance of approximately 500 mm between the ears. MEMS devices base on the principles of operation of O. ochracea's hearing system have been well studied, however commercial implementation has proven challenging due to the system's reliance on carefully tailored ratios of stiffness and damping, which are difficult to realize in standard MEMS fabrication processes, necessitating a trade-off between wide-band operation and sensitivity. A survey of the variety of strategies that have been followed to address these inherent challenges is presented.