1 May 2023 in IEEE Microwave and Wireless Technology Letters
A $Ka$ -band 64-element deployable active phased-array transmitter (TX) on a hetero segment liquid crystal polymer (LCP) substrate for small satellites is proposed. The proposed phased-array TX achieved a large array size implementation and a small form factor with integrated six-layer and two-layer LCP substrates. Antenna and transmission line designs considering hetero layer structure are presented in detail. Achieving 46.7 dBm electronically isotropically radiated power (EIRP), the proposed phased-array TX can support 256-APSK DVB-S2X. As a result, the proposed deployable active phased-array TX successfully realizes low-launch cost with a 9.65 g lightweight and large antenna aperture size with superior EVM performance.
3 July 2023 in IEEE Access
Lightweight and deployable phased arrays are important in Small-Satellite (Small-Sat) constellation systems to reduce price and increase link distance. This article proposes a Ka-band deployable active phased-array TX on a 4-layer liquid crystal polymer (LCP) board for a lightweight and high stowage rate solution to break through the trade-off between high antenna aperture size and small form factor in phased arrays. This article describes detailed designs of the phased array and its building blocks with the proposed 4-layer LCP substrate structure. Assembled with the beamformer ICs (BFIC), a Ka-band 8×4-element deployable active phased-array TX on the 4-layer LCP substrate is fabricated. The proposed deployable phased-array TX can steer the beam from -50° to 50°. The phased-array TX can drive 32-APSK DVB-S2 signal with a -28.7 dB EVM as well, revealing that the deployable phased-array TX performs with high phased-array performance. Furthermore, the TX achieved the lightest and thinnest phased array with 0.96 kg/m 2 areal mass and 0.9 mm thickness. This groundbreaking research sets the stage for the realization of affordable and user-centric satellite communication (SATCOM) in low-earth orbit (LEO).
11 January 2024 in IEEE Solid-State Circuits Letters
This letter describes a fully synthesizable fractional- $N$ multiplexing delay-locked loop (MDLL) with a ring-oscillator-based digital-to-time converter (RO-DTC). The proposed RO-DTC can generate a wide range of time delays with only a relatively smaller number of delay cells. Since its structure is periodical, the corresponding predistortion look-up table (LUT)’s size could also be reduced. The proposed MDLL is implemented in a 65-nm CMOS process. The measured results show that the RO-DTC’s power normalized by operating frequency and tuning range is the lowest among other state-of-the-art works. The proposed MDLL achieves FoMs of −242.3 and −218.6 dB in integer- $N$ and fractional- $N$ operation modes at RF frequencies 1.04 and 1.0465 GHz. The core area is 0.0892 mm2.
12 August 2025 in IEEE Access
This article presents a 256-element CMOS active phased-array transmitter (TX) that works in Ka-band downlink for low earth orbit (LEO) small satellite communication (SATCOM) applications. The phased array adapts an on-chip monitor circuit which can be used to detect the amplitude and phase for calibration. The TX chip’s output 1 dB compression point (OP1dB) is 11dBm and saturated output power (Psat) is 12dBm for every path. The phased array can support single circular polarization (CP) and dual circular polarization modes. The maximum effective isotropic radiated power (EIRP) for the single CP wave can reach 64.6 dBm under a power consumption of 37.4W. The error vector magnitude (EVM) of this work can support 256APSK modulation in both single CP mode (at 2 Gbaud symbol rate) and dual CP modes (at 250Mbaud symbol rate). As for beam steering ability, the phased array can cover a beam angle of ±66°. Compared to the conventional TX, this work has a larger beam angle and EIRP without sacrificing too much power consumption.
31 March 2026 in IEEE Journal of Solid-State Circuits
This article presents a 256-element CMOS active phased-array transmitter (TX) that works at 19 GHz for low-Earth orbit (LEO) satellite applications. This work proposes a 90° coupler-end structure for circular polarization (CP) wave generation, which features low power consumption and enables dual-CP waves emitting in two directions. In addition, this work employs two calibration techniques to improve cross-polarization discrimination (XPD) in single-CP and dual-CP modes. The power consumption of the proposed structure is 9.4 W at 56-dBm average effective isotropic radiated power (EIRP), which is 40% lower than the state-of-the-art. It consumes 17.8 W at 64.7-dBm maximum EIRP. The beam-steering ability of this work can achieve ±65° with a sidelobe level <10-dBc. For the EVM measurement result, in single-CP mode, this work can support 256 amplitude-phase shift keying (APSK) modulation with a 2-Gbaud symbol rate on a 56-dBm EIRP output. In dual-CP mode, this work can support 256 APSK modulation with a 250-MBaud symbol rate on a 56-dBm EIRP output.
10 November 2025 in IEEE Transactions on Microwave Theory and Techniques
This work presents three different phased arrays achieving simultaneous operation for low earth orbit (LEO) satellite communication (SATCOM). The first phased array is a CMOS only transceiver (TRX) beamforming IC (BFIC) using a 65 nm CMOS process that utilizes self-duplexing antennas, which are presented to highlight the efficacy of the antennas. Next, this phased array is extended into the second phased array which includes a one path D-mode GaAs LNA and provides the foundation for the methods of taking advantage of the simultaneous operation of SATCOM to produce a small and simple printed circuit board (PCB) design while improving noise performance in the receiver (RX). Finally, the third phased array expands upon this to include a two path GaAs TRX which can highlight the use of single versus multipath beamforming chips within heterogenous TRXs and also improves the transmitter (TX) performance. The second phased array takes advantage of the simultaneous operation of SATCOM to bias the GaAs LNA by coupling some of the TX output to a 5-stage rectifier to generate a negative voltage. The third phased array uses the same method of coupling some of the TX signal to generate a negative voltage, which is done through a three-line coupler so that the GaAs PA and LNA can be biased independently. All three designs are capable of beamsteering and can support transmitting and receiving 400 MBaud 256-APSK signals simultaneously in over-the-air (OTA) measurements.