Atsushi Shirane

Atsushi Shirane

Auto-generated profile, based on publicly available information

Atsushi Shirane

Department of Electrical and Electronic Engineering, Institute of Science Tokyo, Tokyo, Japan

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 October 2019 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Closed access
HZHaosheng Zhang
Haosheng Zhang
KOKenichi Okada
Kenichi Okada
HHHans Herdian
Hans Herdian
ANAravind Tharayil Narayanan
Aravind Tharayil Narayanan
ASAtsushi Shirane
Atsushi Shirane
SYShinya Yanagimachi
Shinya Yanagimachi
This article introduces a chip-scale ultralow-power atomic clock (ULPAC) in the microwave frequency region. A new suspended quantum package architecture along with a fully integrated frequency probing and locking loop implemented in CMOS technology results in a compact package and ultralow-power consumption. In addition, dedicated low-noise magnetic field and temperature control loops are incorporated for isolating and mitigating the internal and external factors affecting the frequency stability. The output frequency of a crystal oscillator is continuously compensated and stabilized by locking to the peak of a coherent population trapping signal, thereby inheriting the superior frequency stability of the atomic resonance. The proposed ULPAC system achieves a frequency stability of 2.2 x 10⁻¹² at an averaging time of 10⁵ s, while consuming 59.9 mW. The frequency probing and locking circuits implemented in a standard 65-nm CMOS process node occupy an area of 2.55 mm². The prototype of this atomic clock occupies a volume of 15 cm³.

11 January 2024 in IEEE Solid-State Circuits Letters
Verified
Journal Article
Open access
HHHóngyè Huáng
Hóngyè Huáng
BLBangan Liu
Bangan Liu
ZLZezheng Liu
Zezheng Liu
DXDingxin Xu
Dingxin Xu
YZYuncheng Zhang
Yuncheng Zhang
KOKenichi Okada
Kenichi Okada
This letter describes a fully synthesizable fractional- $N$ multiplexing delay-locked loop (MDLL) with a ring-oscillator-based digital-to-time converter (RO-DTC). The proposed RO-DTC can generate a wide range of time delays with only a relatively smaller number of delay cells. Since its structure is periodical, the corresponding predistortion look-up table (LUT)’s size could also be reduced. The proposed MDLL is implemented in a 65-nm CMOS process. The measured results show that the RO-DTC’s power normalized by operating frequency and tuning range is the lowest among other state-of-the-art works. The proposed MDLL achieves FoMs of −242.3 and −218.6 dB in integer- $N$ and fractional- $N$ operation modes at RF frequencies 1.04 and 1.0465 GHz. The core area is 0.0892 mm2.

1 January 2025 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Open access
MTMinzhe Tang
Minzhe Tang
YZYi Zhang
Yi Zhang
JPJian Pang
Jian Pang
ZLZheng Li
Zheng Li
DXDongfan Xu
Dongfan Xu
KOKenichi Okada
Kenichi Okada

11 September 2023
Verified
Conference Paper
Closed access
CLChenxin Liu
Chenxin Liu
IAIbrahim Abdo
Ibrahim Abdo
CWChun Wang
Chun Wang
HSHiroyuki Sakai
Hiroyuki Sakai
ASAtsushi Shirane
Atsushi Shirane
KOKenichi Okada
Kenichi Okada
This work presents a dual-mode bi-directional CMOS mixer designed for communication systems operating in the 300GHz band, which is encompassed in the frequency band of IEEE Std 802. 15.3d(252.72GHz-321.84GHz). The mixer can operate in either doubler-based nonlinearity up-conversion mode or 2nd-harmonic down-conversion mode. The proposed mixer features a differential push-push doubler with modecontrol switches attached to the source, as well as a D-band Marchand balun at the input port to provide differential signals. In up-conversion mode, the intermediate-frequency (IF) and local-oscillator (LO) signals are added at the gate of the doubler to obtain the radio frequency (RF) at the drain through second-order nonlinearity. In down-conversion mode, the second harmonic frequency of the differential LO signal applied to the gate multiplies with RF to generate the IF at the source. The mixer was fabricated using a 65-nm CMOS process. The upconversion mode’s saturated output power and maximum conversion gain are -5.7dBm and -10dB, respectively. The maximum conversion gain of the down-conversion mode is - 15dB.

23 September 2025 in IEEE Journal of Solid-State Circuits
Verified
Journal Article
Open access
YZYuncheng Zhang
Yuncheng Zhang
ZLZezheng Liu
Zezheng Liu
DLDuo Li
Duo Li
MTMinzhe Tang
Minzhe Tang
YZYi Zhang
Yi Zhang
KOKenichi Okada
Kenichi Okada
Conventional digital polar transmitters (TXs) suffer from limited power efficiency and linearity due to the multi-bit nature of intermediate signals. This work proposes a digital polar TX architecture that avoids such drawbacks by reducing the bit count of TX signals. The proposed TX oversamples and quantizes multi-bit I/Q inputs into three-level signals using simple delta-sigma modulators (DSMs), followed by a nine-state lookup table (LUT) to directly generate amplitude modulation (AM) and phase modulation (PM) signals. The complex coordinate rotation digital computer (CORDIC) that is widely used in polar TXs is not required. The AM signal is truncated to two levels for on/off control of an intrinsically linear 1-bit power amplifier (PA). The PA avoids the linearity and switching loss issues of conventional switched-capacitor PAs (SCPAs). The PM signal is represented with 3 bits for eight-phase generation via edge selection from a $4\times $ carrier local oscillator (LO), which offers better linearity and power efficiency than phase modulators based on multi-bit digital-to-time converters (DTCs). Therefore, the proposed approach enables simultaneous improvements in power efficiency and linearity. Fabricated in a 65-nm CMOS process, the proposed TX achieves a 33.5% peak power-added efficiency (PAE) at 24.2-dBm output power and supports wideband 50-MSymbol/s 256-quadratic-AM (QAM) signals without digital predistortion (DPD). A maximum system efficiency (SE) of 24.5% is achieved at −25.1-dB error vector magnitude (EVM), demonstrating superior performance compared to state-of-the-art DPD-less digital polar TXs.

13 September 2021
Verified
Conference Paper
Closed access
ZSZheng Sun
Zheng Sun
DXDingxin Xu
Dingxin Xu
JQJunjun Qiu
Junjun Qiu
ZLZezheng Liu
Zezheng Liu
YZYuncheng Zhang
Yuncheng Zhang
KOKenichi Okada
Kenichi Okada
This paper demonstrates a compact BLE transmitter (TX) achieving fully on-chip integration and high system-efficiency. This BLE TX is constructed based on a 1.2 GHz 8-phases current-reused ring oscillator (RO) with a digital phase-locked loop (PLL). To mitigate the spurious emission, including HD2 caused by phase mismatches, an edge-timing calibration is proposed by reusing the digital PLL in this paper. A transformer-based Class-D PA with implicit LC-notch is implemented to improve the system efficiency with higher harmonic suppression for both HD2 and HD3 with a compact on-chip area. The presented TX supports both 1 Mbps and 2 Mbps GFSK modulation with low power consumption.