We demonstrate graded-index-separate-confinement-heterostructure InGaN laser diodes (GRINSCH) grown by metal organic vapor phase epitaxy. In this type of structure, the optical mode is confined close to the active region by cladding layers with linearly changing Al content. The virtue of this structure lies in simultaneous improvement of injection efficiency through the funneling effect and mode confinement. After a careful modeling we demonstrate that GRINSCH InGaN laser indeed possess very encouraging properties. Low threshold current density of around 3.5 kA/cm2 accompanied by high differential gain (dG/dJ = 14.93 cm kA−1) make these devices an interesting alternative for the classical step-index structure.
In this work we investigate the role of threading dislocations in nitride light emitters with different indium composition. We compare the properties of laser diodes grown on the low defect density GaN substrate with their counterparts grown on sapphire substrate in the same epitaxial process. All structures were produced by metalorganic vapour phase epitaxy and emit light in the range 383–477 nm. We observe that intensity of electroluminescence is strong in the whole spectral region for devices grown on GaN, but decreases rapidly for the devices on sapphire and emitting at wavelength shorter than 420 nm. We interpret this behaviour in terms of increasing importance of dislocation related nonradiative recombination for low indium content structures. Our studies show that edge dislocations are the main source of nonradiative recombination. We observe that long wavelength emitting structures are characterized by higher average light intensity in cathodoluminescence and better thermal stability. These findings indicate that diffusion path of carriers in these samples is shorter, limiting the amount of carriers reaching nonradiative recombination centers. According to TEM images only mixed dislocations open into the V-pits, usually above the multi quantum wells thus not influencing directly the emission.
We have determined thermal stability of various InGaN laser diodes emitting in the spectral range of 390-436 nm. Their characteristic temperature T0 increases steeply with the increasing emission wavelength, reaching the value of around 230 K. Our analysis of current-light characteristics and activation energy of electroluminescence proves that this behavior is predominantly related to the thermal escape of electrons from quantum wells, which depends critically on their depth.
We demonstrate the influence of the operation current density and temperature on the degradation rate of InGaN laser diodes grown via metalorganic vapor-phase epitaxy (MOVPE) and plasma-assisted molecular beam epitaxy (PAMBE). The degradation rate of the MOVPE devices shows an exponential dependence on the temperature, with an activation energy of 0.38–0.43 eV, and a linear dependence on the operating current density. In comparison, the MBE-grown lasers exhibit a higher activation energy, on the order of 1 eV, and typically a lower degradation rate, resulting in a service time exceeding 50,000 h. We suggest that this difference may be related to the lower concentration of H in the Mg-doped MBE-grown GaN.
We studied the InGaN laser diode, emitting in the blue region of the spectrum and characterized by a negative characteristic temperature T0. The corresponding decrease in the threshold current with the increase in temperature for this device is caused by the increased distance between the electron-blocking layer and the quantum wells. Because of the non-monotonic temperature dependence of laser parameters, we can demonstrate a correlation of the degradation rate with nonradiative part of the total device current. This result indicates the potential importance of the recombination processes occurring outside of the active region for the reliability of InGaN laser diodes.