Jian Jiao

Jian Jiao

Auto-generated profile, based on publicly available information

Jian Jiao

Institute of Novel Semiconductors and the State Key Laboratory of Crystal Materials, Shandong University, Jinan, China

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 September 2023 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
XSXun Sun
Xun Sun
LXLongfei Xiao
Longfei Xiao
CLChongbiao Luan
Chongbiao Luan
ZFZhuoyun Feng
Zhuoyun Feng
HSHuiru Sha
Huiru Sha
XXXiangang Xu
Xiangang Xu
Silicon carbide (SiC) is a wide-bandgap semiconductor suitable for high-power high-voltage devices, especially the feasibility and superiority of SiC photoconductive semiconductor in microwave generation have been demonstrated via linear operating mode. Here, the photoconductive semiconductor switch (PCSS) with a channel length of 0.5 mm is fabricated as planar structures on high-purity semi-insulating 4H-SiC. The experimental results show that the voltage transmission of the elliptic morphology laser incident from the rear is larger than the circular counterpart, which is consistent with the formula calculation and the simulations of the current density distribution of a 2-D cross section. Upon the elliptic incident laser centered at ∼355 nm, the peak voltage transmission efficiency of SiC PCSS is 99.5% at the biased voltage of ∼2220 V. In addition, the output voltage waveform is observed with a half-height width of roughly 1.6 ns and rise time of less than 300 ps as well as the minimum on -state resistance of approximately 0.3 Ω at this moment.

3 October 2024 in ACS Photonics
Verified
Journal Article
Closed access
JJJian Jiao
Jian Jiao
LXLongfei Xiao
Longfei Xiao
XSXun Sun
Xun Sun
YLYangfan Li
Yangfan Li
HSHuiru Sha
Huiru Sha
XXXiangang Xu
Xiangang Xu

12 November 2024 in IEEE Transactions on Electron Devices
Verified
Journal Article
Closed access
YLYangfan Li
Yangfan Li
LXLongfei Xiao
Longfei Xiao
CLChongbiao Luan
Chongbiao Luan
XSXun Sun
Xun Sun
HSHuiru Sha
Huiru Sha
XXXiangang Xu
Xiangang Xu
To minimize the rise time and full-width at half-maximum (FWHM) of the output waveform, we have designed and fabricated a novel integrated device based on semi-insulated silicon carbide (SiC) material, which we call cPCSS device, whose structure includes a photoconductive semiconductor switch (PCSS) and a charging capacitor. Test results indicate that, owing to optimized circuit connections and a simplified electrical length in cPCSS, the parasitic capacitance and inductance in the test circuit are decreased. Consequently, the cPCSS device exhibits faster signal while maintaining basically equal conductivity. At the incident laser energy (10 $\mu$ J), cPCSS obtains the output signal with the fastest rise time of 122 ps (10%–90%) and FWHM of 375 ps. In addition, the cPCSS device can maintain a peak output voltage exceeding 10 kV and continuously output signals for more than 180 000 times without any faults.

17 June 2024 in Journal of Applied Physics
Verified
Journal Article
Open access
PDF file
YLYangfan Li
Yangfan Li
LXLongfei Xiao
Longfei Xiao
CLChongbiao Luan
Chongbiao Luan
YQYan Qin
Yan Qin
XSXun Sun
Xun Sun
XXXiangang Xu
Xiangang Xu
A novel high-power AlGaN/GaN heterojunction lateral photoconductive semiconductor switch (PCSS) based on the SiC substrate is proposed, which achieves high dark-state resistance characteristics by groove etching. Under the action of biased electric field and incident laser, a high concentration of two-dimensional electron gas is formed at the heterojunction interface. The photo-generated free carriers transport along the heterojunction interface, which improves the utilization efficiency of photo-generated carriers. Moreover, the simulation of the current density distribution of the PCSS provides theoretical support for this phenomenon. Compared with the conventional GaN PCSS, the power capacity and conduction characteristics are further improved. The test results show that the output current of the device increases significantly after the introduction of the AlGaN/GaN heterojunction. At the biased voltage of ∼34 kV, the maximum output current of the AlGaN/GaN PCSS reaches 205 A.

22 September 2020 in Geophysical Journal International
Verified
Journal Article
Closed access
MZMeng Zhu
Meng Zhu
QZQiming Zeng
Qiming Zeng
JJJian Jiao
Jian Jiao
SUMMARY: Although many studies have revealed that the atmospheric effects of electromagnetic wave propagation (including ionospheric and tropospheric water vapour) have serious impacts on Interferometric Synthetic Aperture Radar (InSAR) measurement results, atmospheric corrections have not been thoroughly and comprehensively investigated in many well-known cases of InSAR focal mechanism solutions, which means there is no consensus on whether atmospheric effects will affect the InSAR focal mechanism solution. Moreover, there is a lack of quantitative assessment on how much the atmospheric effect affects the InSAR focal mechanism solution. In this paper, we emphasized that it was particularly important to assess the impact of InSAR ionospheric and tropospheric corrections on the underground nuclear explosion modelling quantitatively. Therefore, we investigated the 4th North Korea (NKT-4) underground nuclear test using ALOS-2 liters-band SAR images. Because the process of the underground nuclear explosion was similar to the volcanic magma source activity, we modelled the ground displacement using the Mogi model. Both the ionospheric and tropospheric phase delays in the interferograms were investigated. Furthermore, we studied how the ionosphere and troposphere phase delays could bias the estimation of Mogi source parameters. The following conclusions were drawn from our case study: the ionospheric delay correction effectively mitigated the long-scale phase ramp in the full-frame interferogram, the standard deviation decreased from 1.83 to 0.85 cm compared to the uncorrected interferogram. The uncorrected estimations of yield and depth were 8.44 kt and 370.33 m, respectively. Compared to the uncorrected estimations, the ionospheric correction increased the estimation of yield and depth to 9.43 kt and 385.48 m, while the tropospheric correction slightly raised them to 8.78 kt and 377.24 m. There were no obvious differences in the location estimations among the four interferograms. When both corrections were applied, the overall standard deviation was 1.16 cm, which was even larger than the ionospheric corrected interferogram. We reported the source characteristics of NKT-4 based on the modelling results derived from the ionospheric corrected interferogram. The preferred estimation of NKT-4 was a Mogi source located at 129°04′22.35‘E, 41°17′54.57″N buried at 385.48 m depth. The cavity radius caused by the underground explosion was 22.66 m. We reported the yield estimation to be 9.43 kt. This study showed that for large-scale natural deformation sources such as volcanoes and earthquakes, atmospheric corrections would be more significant, but even if the atmospheric signal did not have much complexity, the corrections should not be ignored.

16 May 2025 in IEEE Journal of Selected Topics in Quantum Electronics
Verified
Journal Article
Closed access
HSHuiru Sha
Huiru Sha
CLChongbiao Luan
Chongbiao Luan
LXLongfei Xiao
Longfei Xiao
HLHongwei Liu
Hongwei Liu
JYJianqiang Yuan
Jianqiang Yuan
HLHongtao Li
Hongtao Li
In this paper, software is used to simulate the conduction characteristics of silicon-based light-initiated multi-gate semiconductor switches. The switching processes of silicon-based light-initiated single-gate semiconductor switches and multi-gate semiconductor switches are compared. The transient state distribution characteristics of carriers during the switching process are analyzed, and the transport mechanism of carriers in the switches is investigated. The electron–hole pairs generated by a laser in the P-base region undergo both transverse diffusion and longitudinal transmission. The light-initiated multi-gate semiconductor switches exhibit shorter carrier transverse diffusion times and larger opening areas, resulting in increased maximum current and the current response speed after switch conduction. Moreover, we analyze the influence of different laser energies and distributions modes on the light-initiated multi-gate semiconductor switch. Lower laser energy activates the J1 junction but cannot trigger the J3 junction of the switch. Consequently, the carrier concentration remains low, and the switch does not fully open. Compared with a 980 nm laser diode (with a pulse width of 200 ns), a 980 nm Gaussian laser (with a half-peak width of 10 ns) enables faster switch activation.