6 October 2020 in IEEE Transactions on Electromagnetic Compatibility
20 June 2023 in IEEE Transactions on Consumer Electronics
Switched-mode power supplies (SMPS) are the source of both conducted and radiated electromagnetic interference (EMI) noise. Resonant converters are popular due to the possibility of switching loss reduction using zero voltage switching (ZVS) or zero current switching (ZCS) and also attenuating conducted EMI noise. Conventionally, a common-mode (CM) choke with a single core and two identical windings is used to suppress the CM noise in an EMI filter. This paper introduces an effective and cost-efficient method for mitigating the CM EMI noise in SRCs. The proposed method benefits a two-winding coupled inductor instead of the simple resonant inductor in the SRC. While a unity turn ratio does not meet the desired resonance inductance, the suggested two windings coupled inductor with an unequal number of turns deals with the EMI noise as well as the normal operation of an inductor in the resonant tank. Applying the proposed method significantly achieves up to 20 dB attenuation in the noise amplitude both at the input and output terminals of the converter. Simulations are used for investigating the analysis of the method. Moreover, a series resonant converter is designed and implemented to verify both analysis and simulations.
1 January 2025 in IET Power Electronics
Switch mode power supplies (SMPSs) are the source of radiated and conducted EMI noise. The radiated part is usually mitigated by adding proper shielding. The conducted part propagates through the input and output terminals to the power lines and loads. The most common approach to attenuate the conducted noise is benefiting the EMI filter. Implementation of an EMI filter needs to have some information about the source of noise, such as its impedance and amplitude. This information could be obtained by applying proper approaches, categorised into lumped or behavioural methods. In this paper, a behavioural method (spectral analysis) is used to model the conducted EMI noise, generated by a DC–DC converter. The proposed method can estimate the transfer function of both common mode (CM) and differential mode (DM) noise separately. Time domain data is used to identify model, utilising an uncomplicated setup. The experimental results are presented to verify the theory of the suggested method. The results show, there is less than a 5 dB deviation between the obtained model and the verification data set. Also, an EMI filter and a notch filter have been implemented based on the extracted model to show the effectiveness of the suggested method in practice.