1 October 2019 in IOP Conference Series: Materials Science and Engineering
The aim of the work is to increase the well completion efficiency when using oil-based drilling fluids. In this study, the effect of the aqueous phase content on the change in the rheological parameters of the solutions and the effect of the type of asphalt on the structural-rheological and filtration parameters of the oil-based solution was conducted. Studies have shown the effectiveness of various types of asphalt in OBM systems, the obtained dependencies on the effect of the Oil-water ratio can be used in production to select the optimal ratio for the selection of specific properties of solutions.
4 April 2019 in ENERGETIKA. Proceedings of CIS Higher Education Institutions and Power Engineering Associations
In this article, the authors reviewed a new technology to prevent the formation of asphalt-resin-paraffin deposits by the thermal method of electrothermal impact on the oil wellbore shaft using a wind-electric installation as an autonomous power source. The advantage of this thermal stimulation technique lies in its continuous nature, which will allow keeping the clear opening of the tubing constant. The scheme of the autonomous system for down-hole electric heating of oil is presented. A tubular or induction heater can serve as an electric heating element placed in the well. The heating element of the system can be used in the wells exploited by freeflow, gas lift and mechanized methods, while its installation does not require an overhaul. The paraffin oil saturation temperature and temperature distribution over the depth of the well were defined. The amount of heat, which must be transferred to the oil mixture in the tubing in order to ensure effective operation of the well, taking into account the dynamic state of the system, is calculated. The optimal depth of the heating element's location in the well and its power was determined. The calculation of the required power for wind-electric installation to maintain the set temperature in the wellbore was performed. Having conducted the studies, it was revealed that in order to prevent the asphalt-resin-paraffin deposits formation on the tubing walls of oil wells, it is expedient to use the in-line heater, which maintains the average steady-state temperature along the wellbore and at the wellhead above the initial crystallization point of the asphaltresin-paraffin deposits. The application of the developed electrothermal system is relevant in the conditions of formation of asphalt-resin-paraffin deposits in the wellbore shaft at the fields, which do not have a connection to the centralized power grid.
1 January 2019 in Science & Technique
Combination of hydrodynamic impact on the formation with acid treatment may be seen as a promising direction in the field of well development and repair in complex geological conditions. With multiple repetition of hydraulic shocks in conjunction with the injection of acid solution, the depth and opening of cracks gradually increases, which contributes to a deeper penetration of the acid solution into the reservoir. The article presents analytical studies, which are aimed at determining the effectiveness of applying the technology of hydrodynamic impact on the bottomhole zone of an oil reservoir when using two fluids with different viscoelastic characteristics as a working fluid. They are devoted to determining the pressure drop at the borehole bottom depending on the initial applied pressure at the wellhead, the velocity of the shock wave, the viscosity of the working and well fluid, and their quantity. These studies were based on the well-known models of Thomson - Tat and Maxwell, considering viscous liquid flow. The dependence obtained proves that with an increase in the pressure pulse generated at the wellhead, the development of pressure pulses at the borehole bottom is a power-law dependence, and with significant volumes of fluid in contact with the bottomhole formation zone, the pressure drop generated at the borehole bottom does not depend only on pressure pulses generated at the wellhead, but also on the dynamic viscosity of this fluid. Conducted studies have shown the effectiveness of hydrodynamic impact technology application when using two liquids with different viscoelastic characteristics and obtaining a synergistic effect during the development and repair of wells in low-permeable reservoirs. Analytical studies were based on data from previously conducted experimental industrial tests on the operating injection well.
31 May 2018 in Gornyi Zhurnal