Global climate change poses a challenge to the mineral development industry in the Arctic regions. Civil and industrial buildings designed and constructed without consideration of warming factors are beginning to collapse due to changes in the permafrost structure. St. Petersburg Mining University is developing technical and technological solutions for the construction of remote Arctic facilities and a methodology for their design based on physical and mathematical predictive modeling. The article presents the results of modeling the thermal regimes of permafrost soils in conditions of thermal influence of piles and proposes measures that allow a timely response to the loss of bearing capacity of piles. Designing pile foundations following the methodology proposed in the article to reduce the risks from global climate change will ensure the stability of remote Arctic facilities located in the zone of permafrost spreading.

Uncontrolled inflow of formation fluid (brine) into a well adversely affects the cation–anion bonds in solutions and leads to their dissociation and loss of aggregative stability. Blow-out significantly complicates the drilling process and leads to an increase in non-productive time and in financial costs for problem solving. It is necessary to create a blocking screen that allows separation of the layer from the well and prevents brine flow. This article is devoted to the development of polymeric-blocking compositions that work due to the crystallization reaction of divalent salts of calcium and magnesium chlorides. More than 14 components were detected in the formation fluid on the atomic emission spectrometer. Based on the study of the compatibility of components with brine and the study of rheology and filtration processes through a real core under HPHT conditions, the optimal component polymer composition was selected. The reason for the increase in the rheology of composition during its thickening was established. With the help of tomographic studies, the depth of penetration of the filtrate into the core of layers was determined. For further studies, an experimental stand was designed for physical simulation of the isolation process under HPHT conditions and backpressure from the formation.

The aim of the work is to increase the well completion efficiency when using oil-based drilling fluids. In this study, the effect of the aqueous phase content on the change in the rheological parameters of the solutions and the effect of the type of asphalt on the structural-rheological and filtration parameters of the oil-based solution was conducted. Studies have shown the effectiveness of various types of asphalt in OBM systems, the obtained dependencies on the effect of the Oil-water ratio can be used in production to select the optimal ratio for the selection of specific properties of solutions.

During the construction of directional wells in spatially curved sections of the barrel, large contact loads and huge resistance to the movement of the drill string during lifting can occur, which leads to increased wear of the drill pipes and high energy costs. One of the directions for increasing the energy efficiency of drilling such wells was the reduction of friction at the metal-metal, metal-rock, and metal-filter cake boundaries. This result can be achieved by introducing special lubricating additives or by switching to a hydrocarbon solution during drilling. The article presents the study of drilling fluids with the introduction of lubricating additives on a lubricity tester Fann EP / Lubricity Tester Model 212, a device for determining the coefficient of clay cake KTK-2, a rotary viscometer Fann 35SA, pH meter Crison GLP 21 to reduce the coefficient of friction of a pair “metal – metal” in a clay solution, which amounted to 70-75%, in an aqueous solution - up to 65%. The optimal concentration of the additive according to the study in different drilling fluids was about 1.5-2%. The results of a study of the effect of the speed and time of mixing a hydrocarbon-based solution during its preparation on the electrostability of the emulsion obtained are carried out on a BVD device, which showed a significant increase in the stability of the washing liquid to 24%, which leads to a decrease in the number of complications associated with pipe wear and a decrease torque when rotating the column.