7 February 2017 in IEEE Transactions on Magnetics
This paper proposes the optimization of the shape and size of a ferrite magnet and the arrangements necessary to reduce torque ripple and maximize back electromotive force (B-EMF) in a permanent-magnet-assisted synchronous reluctance motor. First, four different models of general magnet arrangements were selected, and analysis using the finite-element method was performed under open circuit and load operations for each of the four models. Next, the relationship between the cogging torque and the torque ripple was analyzed, considering the segment saturation phenomenon. Then, based on the initial model, the design was optimized for maximum B-EMF and minimum torque ripple, and the total harmonic distortion was measured. Finally, the validity and superiority of the optimized design were confirmed by manufacturing a prototype motor and performing the experiment.
20 January 2017 in IEEE Transactions on Magnetics
Recently, the permanent magnet-assisted synchronous reluctance motor (PMa-SynRM) that can replace induction motor has been more studying because of the needs of the high efficiency motor development for minimum energy performance standard. PMa-SynRM requires the speed and position information of rotor to control motor correctly. However, sensor for rotor information has many problems such as mounting space shortage and the additional system cost. Therefore, in this paper, the speed-sensorless control based on reference model adaptive control is introduced to eliminate the sensor. And mechanical design is improved for control. The proposed method is verified by simulation.
31 March 2017 in Journal of Magnetics
8 January 2018 in IEEE Transactions on Applied Superconductivity
Generally, brushless dc (BLDC) motor control uses a 120° conduction method that utilizes a low-cost Hall sensor as a position sensor. However, because of the mounting position error of the Hall sensor and the uneven magnetic flux density of the rotor, an erroneous position signal may be output, which will adversely affect the BLDC motor control. Therefore, this paper analyzes the abnormal electric current section that occurs due to the position error of the Hall sensor and the uneven magnetic flux density. Subsequently, the error is derived from the analyzed phenomenon as a formula. The compensation control algorithm to overcome the control problem due to this error is studied, and a method to maintain an accurate energization interval is suggested. Further, it is shown through experiments that the quantitative analysis of the error using the proposed compensation control algorithm is valid.
2 January 2017 in Journal of Electrical Engineering & Technology
2 January 2017 in Journal of Electrical Engineering & Technology
A Maximum Power Control of IPMSM with Real-time Parameter Identification Real-time parameter tracking algorithm;Inductance identification;Maximum power control;IPMSM; This paper proposed a new real-time parameter tracking algorithm. Unlike the convenience algorithms, the proposed real-time parameter tracking algorithm can estimate parameters through three-phase voltage and electric current without coordination transformation, and does not need information on magnetic flux. Therefore, it can estimate parameters regardless of the change according to operation point and cross-saturation effect. In addition, as the quasi-real-time parameter tracking technique can estimate parameters through the four fundamental arithmetic operations instead of complicated algorithms such as numerical value analysis technique and observer design, it can be applied to low-performance DSP. In this paper, a new real-time parameter tracking algorithm is derived from three phase equation. The validity and usefulness of the proposed inductance estimation technique is verified by simulation and experimental results.