26 January 2018 in IEEE Photonics Technology Letters
High speed optical interconnects require low-power compact electro-optical transmit modules comprising driver circuits and optical modulators. This paper presents a low power 56 Gb/s non-return-to-zero CMOS inverter based driver in 28nm fully depleted silicon-on-insulator CMOS driving a 46 GHz silicon photonic microring modulator. The driver delivers 1 Vpp to the microring modulator from a 75 mVpp input while only consuming 40mW (710 fJ/bit at 56 Gb/s). The realized transmitter shows 4 dB extinction ratio when running of a 1V supply voltage. Transmission experiments up to 2km of single mode fiber show a bit-error-ratio less than 1 · 10−9 at 56 Gb/s.
13 December 2017 in Journal of Lightwave Technology
Long-wavelength vertical-cavity surface-emitting lasers (LW-VCSELs) with emission wavelength in the 1.3-μm region for intensity modulation (IM)/direct detection optical transmissions enable longer fiber reach compared to C-band VCSELs, thanks to the extremely low chromatic dispersion impact at that wavelength. A lot of effort has been recently dedicated to novel cavity designs in order to enhance LW-VCSELs' modulation bandwidth to allow higher data rates. Another approach to further improve VCSEL-based IM speed consists of making use of dedicated driver circuits implementing feedforward equalization (FFE). In this paper, we present a transmitter assembly incorporating a four-channel 0.13-μm SiGe driver circuit wire-bonded to a novel dual 1.3-μm VCSEL array. The short-cavity indium phosphide buried tunnel junction VCSEL design minimizes both the photon lifetime and the device parasitic currents. The integrated driver circuit requires 2.5-V supply voltage only due to the implementation of a pseudobalanced regulator; it includes a two-tap asymmetric FFE, where magnitude, sign, relative delay, and pulse width distortion of the taps can be modified. Through the proposed transmitter, standard single-mode fiber reach of 20 and 4.5 km, respectively, for 28- and 40-Gb/s data rate has been demonstrated with state-of-the-art power consumption. Transmitter performance has been analyzed through pseudorandom bit sequences of both 2 7 -1 and 2 31 -1 length, and the additional benefit due to the use of the driver circuit has been discussed in detail. A final comparison with state-of-the-art VCSEL drivers is also includedt.
1 February 2018 in Electronics Letters
Data centre optical links are migrating to four‐level pulse amplitude modulation (PAM‐4) as a method to extend the data rate while covering longer distances. Vertical‐cavity surface‐emitting lasers (VCSELs) enable the integration of low‐power transmitters, but their non‐linear and bias‐dependent behaviour makes conventional feed‐forward equalisation less effective. This Letter presents a SiGe BiCMOS PAM‐4 driver that boosts the falling‐edge to the bottom level through a selective pre‐emphasis technique. Experiments at 25 GBd (50 Gb/s) reveal that adding selective pre‐emphasis to a 4‐tap equalised current driving a 20.6 GHz VCSEL, relaxes the critical PAM‐4 link budget requirements by >1 dB at the KP4 forward error correction threshold of . The potential of PAM‐4 VCSEL transmitters can be significantly enhanced by including selective pre‐emphasis to the equalisation topology while requiring minimal overhead.