M. E. Muretova

M. E. Muretova

Auto-generated profile, based on publicly available information

M. E. Muretova

Alferov University, 194021, St. Petersburg, Russia

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 November 2019 in Optics Letters
Verified
Journal Article
Closed access
PDF file
FZFedor Zubov
Fedor Zubov
MMMikhail Maximov
Mikhail Maximov
NKNatalia V. Kryzhanovskaya
Natalia V. Kryzhanovskaya
EMEduard Moiseev
Eduard Moiseev
MMMaria Muretova
Maria Muretova
AZAlexey E. Zhukov
Alexey E. Zhukov
We report on direct large signal modulation and the reliability studies of microdisk lasers based on InGaAs/GaAs quantum well-dots. A 23 μm in diameter microlaser exhibits an open eye diagram up to 12.5 Gbit/s and is capable of error-free 10 Gbit/s data transmission at 30°C without temperature stabilization. The ageing tests of a 31 μm in diameter microdisk laser were conducted at room and elevated temperatures during more than 1200 hr. The average rate of the output power degradation was about 25 and 29 nW/hr at 40°C and 60°C, respectively.

5 October 2018 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
FZFedor Zubov
Fedor Zubov
MMM. E. Muretova
M. E. Muretova
LAL. V. Asryan
L. V. Asryan
ESElizaveta Semenova
Elizaveta Semenova
MMM. V. Maximov
M. V. Maximov
AZA. E. Zhukov
A. E. Zhukov
The feasibility of implementation of asymmetric barriers (ABs) made of common materials for completely aluminum-free diode lasers is studied. The ABs adjoining a low-dimensional active region on both sides aim to prevent bipolar population in the waveguide layers and thus to suppress parasitic recombination therein, which in turn would enhance the efficiency and temperature-stability of the device. Our search algorithm for appropriate AB materials relies on the minimization of undesired carrier flow (electrons or holes passing through the active region toward the p- or n-type doped cladding layer, respectively), while maintaining the useful flows of hole and electron injection into the active region. Using an example of an 808-nm GaInAsP laser, it is shown that the n- and p-side ABs can be made, for instance, of GaInPSb and GaInP, respectively. In such a laser, the parasitic recombination flux can be suppressed by a factor of 60 for electrons and 200 for holes. It is found that the contribution of the indirect valleys to the electron flow through the p-side AB can be significant and even decisive in some cases. The contribution of light holes to the transmission through the ABs can also be considerable. The optimal thicknesses of the AB layers are determined and the chemical composition tolerances are estimated for a given flux suppression ratio.

1 March 2020 in Semiconductors
Verified
Journal Article
Closed access
PDF file
FZFedor Zubov
Fedor Zubov
MMM. E. Muretova
M. E. Muretova
APA. S. Payusov
A. S. Payusov
MMM. V. Maximov
M. V. Maximov
AZA. E. Zhukov
A. E. Zhukov
LAL. V. Asryan
L. V. Asryan
In a laser with asymmetric barrier layers (ABLs) two thin barrier layers adjacent to the active region on both sides are intended to prevent bipolar population of the waveguide layers, hence, to suppress parasitic recombination in them. A theoretical model of a laser with ABLs, based on rate equations which acknowledge undesirable carrier leakage inevitable in lasers of this type implemented in practice, is proposed. Solutions to equations are obtained for the steady-state case. By the example of an InGaAs/GaAs quantum-well laser (lasing wavelength λ = 980 nm), the effect of leakages through ABLs on the device characteristics is studied. The parasitic-flux suppression ratios C of ABLs which are required to prevent the adverse effect of waveguide recombination are estimated. In the case at hand, the effect of ABLs becomes appreciable at suppression ratios of C ≥ 102. To suppress 90% of the parasitic current, C should be 2.3 × 104. The effect of ABLs on useful carrier fluxes arriving at the active region is also studied.

7 November 2018 in Semiconductors
Verified
Journal Article
Closed access
PDF file
LAL. V. Asryan
L. V. Asryan
FZF. I. Zubov
F. I. Zubov
YBYu. S. BalezinaPolubavkina
Yu. S. BalezinaPolubavkina
EMEduard Moiseev
Eduard Moiseev
MMM. E. Muretova
M. E. Muretova
AZA. E. Zhukov
A. E. Zhukov
A self-consistent model for calculating the threshold and high-power characteristics of semiconductor quantum well lasers with asymmetric barrier layers is developed. The model, which is...

27 December 2018 in Semiconductors
Verified
Journal Article
Closed access
PDF file
FZFedor Zubov
Fedor Zubov
MMM. E. Muretova
M. E. Muretova
LAL. V. Asryan
L. V. Asryan
ESElizaveta Semenova
Elizaveta Semenova
MMM. V. Maximov
M. V. Maximov
AZA. E. Zhukov
A. E. Zhukov
A search for materials suitable for implementation of 1.55 µm Al-free diode lasers based on InP with asymmetric barrier (AB) layers is conducted. It is shown that a very high (over 106)...

1 June 2018
Verified
Conference Paper
Closed access
MMM.E. Muretova
M.E. Muretova
FZF.I. Zubov
F.I. Zubov
LAL.V. Asryan
L.V. Asryan
ESElizaveta Semenova
Elizaveta Semenova
MMM.V. Maximov
M.V. Maximov
AZA.E. Zhukov
A.E. Zhukov
We study the possibility of realization of the asymmetric barrier layers (ABL) concept in an 808-nm Al-free GaInAsP/InGaP/GaAs semiconductor laser. Two ABLs on both sides of the active region are aimed to suppress the parasitic recombination in the optical confinement layers. It is shown that such ABL-laser can be made fully Al-free having high suppression ratios for parasitic charge carrier flows (60 and 207 times for electrons and holes, respectively, as compared to a conventional SCH heterostructure).