A general high-efficiency time-modulated module and harmonic beam scanning time-modulated array (TMA) are proposed and investigated in this paper. By introducing the periodically controlled phased-shifters, a significant improvement on theoretical overall efficiency and transmitted bandwidth can be realized in harmonic beam scanning. Then equivalent cascade structure of the general modulation module is proposed for RF circuit simplification and practicability in actual applications. Theoretical derivation and simulation results show that increased efficiency, 100% feeding network efficiency and theoretical overall efficiency tending to 100% without consideration of insertion loss, can be achieved with the increase the phase-shifter states when only a single sideband is utilized. Compared to the existing state-of-the-art harmonic beam scanning TMAs, the proposed TMA exhibits a much higher overall efficiency while keeps a similar hardware complexity. Additionally, with acceptable increase of circuit complexity less than existing works, similar level of the wide transmission bandwidth can also be achieved. To experimentally verify the feasibility of the proposed general design, a 4-bit time-modulated module with reconfigurable states and the corresponding 8-element harmonic beam scanning TMA are fabricated and tested. The experiments on signal transmission and harmonic beam scanning demonstrate the effectiveness of power loss reduction and improvement in transmitted bandwidth with the increase of modulation phase states.
3 February 2020 in IEEE Transactions on Antennas and Propagation
A novel beam scanning method utilizing the carrier frequency component for time modulated array (TMA) is proposed and a significant algorithm based on the non-uniform period modulation is implemented to suppress the maximum sideband radiation (SR) level. The signal in each channel is modulated by a pair of high-speed radio- frequency (RF) switches and totally three or four delay lines with different phases. In each modulation period, three selected delay lines are connected successively with proper pulse durations to keep the switches in ”ON” states constantly and ensure the maximum efficiency in the feeding network. Additionally, in order to suppress the relatively higher SR generated by both switches and delay lines, each channel of the TMA system has a different modulation period, which will separate the harmonic components of different elements on the frequency axis. A desired relatively low maximum SR level without complicated optimization is obtained compared to uniform period modulation and optimization algorithms. Several numeric simulations are brought out to examine the performance of the proposed methods, and the results for comparison to existing methods are also provided. A group of experiments have been done to verify its effectiveness.
4 May 2021 in IEEE Transactions on Antennas and Propagation
A novel single-channel direction finding (DF) method with spatial spectrum estimation is proposed based on 1 bit time-modulated array (TMA). Its performance is analyzed from theoretical derivation to numerical simulations and compared with other existing DF methods. The proposed DF method is implemented as follows. First, the received sideband signals from the 1 bit modulated single-channel signal are deduced, followed by the detailed analysis of the received noise distribution. Second, the harmonic recovery (HR) method with the $l_{2} $ -norm approximation is utilized to recover the original array signals. Finally, conventional spatial spectrum estimation methods are easily applied for high-accuracy DF. Meanwhile, The DF accuracy of the proposed 1 bit method is analyzed under the Gaussian noise model, and its Cramér–Rao lower bounds (CRLBs) are deduced for the first time and compared with conventional arrays and other DF TMA systems. Numerical simulations are provided to show that the proposed 1 bit TMA system and HR method can achieve better accuracy performance over the existing TMA systems when the circuit noise is predominant in the received noises. An $S$ -band 1 bit TMA system is fabricated and implemented to experimentally verify the feasibility of the proposed method under circumstances of a single incident source and two coherent sources.
1 October 2021 in IEEE Antennas and Wireless Propagation Letters
In this letter, a novel direction-finding method with spatial spectrum estimation is proposed and verified, based on the time-modulated linear array (TMLA) and a single radio-frequency channel. Its principle is as follows. The TMLA receives and periodically modulates the incident signal. After the power combiner, the modulated signal is down-converted to the intermediate frequency and sampled in the single-channel receiver. In the digital domain, the array manifold vector can be calculated from the Fourier coefficients and the harmonic characteristic matrix related to modulation sequences, and thus, the autocorrelation matrix can be estimated. Afterward, the multiple signal classification algorithm is applied to estimate the incident angle, and the spatial smoothing method is exploited to deal with the direction finding of coherent sources. The proposed method has a simple structure and low computational complexity. Numeric simulations and corresponding experiments have been conducted to verify its effectiveness.
25 May 2020 in IEEE Antennas and Wireless Propagation Letters
A novel single channel LCMV-based adaptive beamforming method with time-modulated array (TMA) is proposed and verified. Time-modulated technique is utilized to generate a modulated single-channel signal. And in digital domain, with l $_2$ norm optimization, covariance matrix of original signal is recovered from the sideband signals, which are extracted from the single-channel signal. Finally the optimal weighting vectors can be determined by linearly constrained minimum variance (LCMV) criterion. The proposed method has lower channel mismatches, hardware complexity and cost comparing to the traditional multi-channel structure. And in the procedure, only fixed time sequences are needed to calculate the weights and obtain the output signal. Simulation results are provided to show the procedure and verify its effectiveness.
31 October 2024 in IEEE Internet of Things Journal
In this paper, a novel multi-stream downlink communication system based on the transmissive reconfigurable intelligent surface (RIS) transceiver is proposed. Specifically, a transmissive RIS transceiver architecture is first elaborated, where the downlink communication mechanism and the difference from the conventional multi-antenna transceivers are introduced, respectively. More importantly, the generation of RIS element control signals based on time-modulated array (TMA) is illustrated in detail, which can jointly take into account multi-stream modulation signals and beamforming design. Correspondingly, the harmonic signal extraction scheme at the user is also given. Then, since the design of beamforming has an impact on the system performance, we propose a beamforming optimization algorithm based on matrix lifting, successive convex approximation (SCA) and difference-convex (DC) programming under the constraints of user signal-to-interference-plus-noise ratio (SINR) and available useful power of RIS elements. Furthermore, we analyze the bit error rate (BER) performance of the proposed architecture from two perspectives of transmit multiplexing and transmit diversity. Finally, the convergence behavior of the beamforming algorithm, the impact of different system parameter configurations on system performance and the BER performance of different schemes under the system are verified by numerical simulations.