The 2D insulating material hexagonal boron nitride (h‐BN) has attracted much attention as the active medium in memristive devices due to its favorable physical properties, among others, a wide bandgap that enables a large switching window. Metal filament formation is frequently suggested for h‐BN devices as the resistive switching (RS) mechanism, usually supported by highly specialized methods like conductive atomic force microscopy (C‐AFM) or transmission electron microscopy (TEM). Here, the switching of multilayer hexagonal boron nitride (h‐BN) threshold memristors with two nickel (Ni) electrodes is investigated through their current conduction mechanisms. Both the high and the low resistance states are analyzed through temperature‐dependent current–voltage measurements. The formation and retraction of nickel filaments along boron defects in the h‐BN film as the resistive switching mechanism is proposed. The electrical data are corroborated with TEM analyses to establish temperature‐dependent current–voltage measurements as a valuable tool for the analysis of resistive switching phenomena in memristors made of 2D materials. The memristors exhibit a wide and tunable current operation range and low stand‐by currents, in line with the state of the art in h‐BN‐based threshold switches, a low cycle‐to‐cycle variability of 5%, and a large On/Off ratio of 107.
Molybdenum disulfide (MoS 2 ) is a layered two-dimensional (2D) semiconducting material with a band-gap ranging from 1.3 eV in bulk to 1.88 eV in mono-layer [1]. This transition metal dichalcogenide (TMD) is being studied as a potential material for nanoelectronics and optoelectronics [2], [3]. Most of the research on electronic devices based on MoS 2 published so far is naturally focused on lateral (in-plane) transport properties. In this work, we investigate MoS2 with respect to its material properties in vertical direction, with a potential application as a dielectric barrier material for vertical heterosturcture devices, such as Graphene-base Hot Electron Transistors (GBTs) [4], [5]. Its low band gap compared to available oxides and its low band offset with respect to silicon (Si) could yield an efficient GBT emission barrier [6]. We discuss Si/MoS 2 /Metal structures based on C-V measurements and propose the method for probing the electronic properties, including defects and interface states, of MoS 2 and other TMDs.
This paper presents promising current-voltage characteristics of semiconductor-insulator-graphene tunnel diodes as the hot-electron injection unit in graphene base transistors (GBTs). We propose that by using a bilayer tunnel barrier one can effectively suppress the defect mediated carrier transport while enhancing the hot-electron emission through Fowler-Nordheim tunneling (FNT) and step tunneling (ST). A stack of TmSiO/TiO 2 (1 nm/ 5.5 nm) is sandwiched between a highly doped Si substrate and a single layer graphene (SLG) as the electrodes. This tunnel diode exhibits high current with large nonlinearity suitable for the application in GBTs.