24 April 2023 in Applied Physics Letters
The effect of majority carrier concentration and minority carrier lifetime on the performance of mid-wave infrared ( λ cutoff = 5.5 μ m ) nBn detectors with variably doped InGaAs/InAsSb type-II superlattice absorbers is investigated. The detector layer structures are grown by molecular beam epitaxy such that their absorbing layers are either undoped, uniformly doped with a target density of 4 × 1015 cm−3, or doped with a graded profile, and variable-area mesa detector arrays are fabricated. Each material's temperature-dependent minority carrier lifetime is determined by time-resolved photoluminescence, and majority carrier concentration is extracted from capacitance–voltage measurements. Detector performance is evaluated with dark current and photocurrent measurements, from which quantum efficiency and shot-noise-limited noise-equivalent irradiance are calculated. The two doped detectors have lower dark current densities compared to their undoped counterpart due to the reduction in diffusion current as well as suppression of depletion current. Although both intentionally doped devices exhibit lower minority carrier lifetimes relative to the undoped device, the device with graded doping maintains a comparable quantum efficiency to the undoped device. Ultimately, the graded doping structure exhibits the highest sensitivity with a shot noise-limited noise-equivalent irradiance of 6.3 × 1010 photons/cm2 s in low-background light conditions, within a factor of 4× of an infrared detector pixel with Rule 07 dark current density and unity quantum efficiency. A detailed analysis of the dark current, quantum efficiency, and minority carrier lifetime provides insight into the material and device design factors that must be considered to realize a device with optimal sensitivity.
5 November 2007 in Proceedings of the IEEE
Quantum-dot infrared photodetectors have emerged as attractive devices for sensing long wavelength radiation. Their principle of operation is based on absorption of radiation via intersublevel transitions in quantum dots. Multiple layers of self-organized ln(Ga)As/Ga(Al)As quantum dots are generally incorporated in the active region of these devices. Three-dimensional quantum confinement allows normal incidence operation. This paper describes a novel variation in the design of these devices which allows a significant reduction of the dark current, high temperature operation and extension of operation to terahertz frequencies. The principle of operation and operating characteristics of this device - the tunnel quantum-dot intersublevel detector - are described. Operation is demonstrated from 6-80 mum at temperatures up to 300 K with acceptable values of peak responsivity (0.1-0.75 A/W) and specific detectivity (107-1011cm ldr Hz1/2/W-1 , depending on temperature and wavelength).
9 October 2023 in Journal of Applied Physics
An investigation into the effects of 63 MeV proton irradiation on high-sensitivity mid-wave infrared InGaAs/InAsSb nBn devices is performed. Three different structures with various absorber region doping profiles are irradiated and characterized to assess their impact on performance degradation. Minority carrier lifetime is measured using time-resolved photoluminescence and lifetime damage factors are assessed. The majority carrier concentration is determined via capacitance–voltage measurements and dopant introduction rates are calculated. An analysis of dark current density is performed using these material parameters, revealing a reduction in mobility with proton fluence and the emergence of a proton-induced trap energy level. Quantum efficiency is calculated at each proton fluence, and quantum efficiency damage factors show that the graded doping structure exhibits the least reduction of quantum efficiency with dose, attributed to its effective mobility enhancement. Conclusively, detector sensitivity, assessed via shot-noise limited noise-equivalent irradiance, shows that the graded doping structure is the least susceptible to high energy proton irradiation-induced performance degradation.
9 March 2023 in Journal of Applied Physics
Capacitance–voltage measurements are a powerful technique to determine doping profiles of semiconductor pn junctions and Schottky barrier diodes. The measurements were recently extended to III-V-based mid-wavelength nBn infrared detectors, and absorber doping densities have been extracted using the widely accepted Schottky approximation, where the potential drop across the device is assumed to be across the depleting absorber layer. However, this approach is limited to when the absorber region of the nBn is under high reverse bias and thus is only able to extract the absorber region doping profile. Here, we introduce a semi-analytical model that is capable of extracting barrier dopant polarity, doping concentration, and thickness, as well as contact and absorber layer doping concentrations, all from a capacitance–voltage measurement. Rather than solely considering the potential drop across the depleting layers, it considers the potential drop across the accumulating layer as well. This negative charge accumulation occurs for the contact and absorber layers in the case of reverse and forward biases, respectively. This allows for a single model to be applied to a capacitance–voltage curve at forward and reverse biases and it can provide regions of bias where the absorber transitions from depletion to accumulation. We compare the agreement of the semianalytical model with modeling results from commercially available finite element method software and experimental capacitance–voltage data. Finally, we show that the method is consistent with the Schottky approximation of extracting absorber doping densities at high reverse bias and discuss the model's limitations.
24 September 2025 in Journal of Applied Physics
Alloys of GaInAsSbBi are grown by molecular beam epitaxy with various Bi compositions and subjected to a collimated beam of 63 MeV protons. Photoluminescence structures are used to evaluate the material’s minority carrier lifetime damage factor, and nBn structures are produced to investigate the detector’s rate of performance degradation. The lifetime damage factors of the photoluminescence structures containing 0.35% and 0.30% Bi are comparable at 2.4 × 10−6 and 2.2×10−6cm2/p+s, respectively, whereas the Bi-free counterpart sample exhibits a significantly higher lifetime damage factor of 3.8×10−6cm2/p+s. Two mid-wave infrared nBn detectors with 0.30% Bi absorbing regions, exhibiting a cutoff wavelength of 4.8 μm, are characterized in situ between step doses for dark current and quantum efficiency, and the dark-current-limited shot-noise-equivalent irradiance is calculated as a function of proton fluence. The noise-equivalent irradiance damage factor for both nBn structures is found to be 3.6 × 10−2 photons/p+, roughly 2.7× lower than other mid-wave infrared superlattice-based nBn detectors.
24 September 2025 in Journal of Applied Physics
GaInAsSbBi nBn photodetectors are grown lattice-matched on GaSb by molecular beam epitaxy. Device structures exhibit smooth surface morphologies, minority carrier lifetimes on the order of 0.5 μs at 130 K, and demonstrate a 4.8 μm wavelength cutoff, a 0.3 μm cutoff extension to a Bi-free GaInAsSb nBn counterpart. Dark current and quantum efficiency measurements of the nBn provide a 3–5 μm in-band shot-noise-limited noise-equivalent irradiance that is ∼12× the Rule 07 reference in which unity quantum efficiency is assumed. The analysis of the device behavior indicates that detector performance is limited by the valence band alignment at the barrier/active region interface, which imparts a barrier to photocollection at lower operating biases and leads to a significant reduction in the quantum efficiency with decreasing temperature. While more investigation is required to optimize the valence band alignment, the results in these detectors indicate that performance comparable to Rule 07 is within reach.