Joshua M. Duran

Joshua M. Duran

Auto-generated profile, based on publicly available information

Joshua M. Duran

Air Force Research Laboratory, Information and Spectrum Warfare Directorate 4 , Wright-Patterson AFB, Ohio 45433

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 January 2018 in IEEE Photonics Journal
Verified
Journal Article
Open access
ASAndrew Sarangan
Andrew Sarangan
JDJosh Duran
Josh Duran
VVVladimir Vasilyev
Vladimir Vasilyev
NLNicholaos Limberopoulos
Nicholaos Limberopoulos
IVIlya Vitebskiy
Ilya Vitebskiy
IAIgor Anisimov
Igor Anisimov
We experimentally demonstrate a thermally induced reflective optical limiter using Ge 2 Sb 2 Te 5 (GST) and SiO 2 in a multilayer photonic bandgap edge-filter configuration. In the PASS state, greater than 80% transmission was achieved at λ ~ 1500 nm over a 300 nm spectral bandwidth and ±45° angles of incidence. In the BLOCK state, extinction ratios higher than 30 dB were achieved. By comparison, all previous optical limiters based on nonlinear photonic crystals have severe spectral bandwidth and/or angle of incidence limitations in either the PASS or BLOCK states. A nine-layer implementation of this device was fabricated and tested in this paper. Numerical modeling results show reasonable agreement with measured values. To the best of our knowledge, this is the first demonstration of optical limiting over a broad spectral band using phase change materials with this level of performance. However, it should be noted that although GST can be switched in both directions, the experimental results demonstrated in this paper are limited to PASS-to-BLOCK switching only.

22 November 2019 in Micromachines
Verified
Journal Article
Open access
PDF file
GAGamini Ariyawansa
Gamini Ariyawansa
JDJoshua Duran
Joshua Duran
CRCharles Reyner
Charles Reyner
JSJohn Scheihing
John Scheihing
This paper reports an InAs/InAsSb strained-layer superlattice (SLS) mid-wavelength infrared detector and a focal plane array particularly suited for high-temperature operation. Utilizing the nBn architecture, the detector structure was grown by molecular beam epitaxy and consists of a 5.5 µm thick n-type SLS as the infrared-absorbing element. Through detailed characterization, it was found that the detector exhibits a cut-off wavelength of 5.5 um, a peak external quantum efficiency (without anti-reflection coating) of 56%, and a dark current of 3.4 × 10−4 A/cm2, which is a factor of 9 times Rule 07, at 160 K temperature. It was also found that the quantum efficiency increases with temperature and reaches ~56% at 140 K, which is probably due to the diffusion length being shorter than the absorber thickness at temperatures below 140 K. A 320 × 256 focal plane array was also fabricated and tested, revealing noise equivalent temperature difference of ~10 mK at 80 K with f/2.3 optics and 3 ms integration time. The overall performance indicates that these SLS detectors have the potential to reach the performance comparable to InSb detectors at temperatures higher than 80 K, enabling high-temperature operation.

24 April 2023 in Applied Physics Letters
Verified
Journal Article
Open access
PDF file
ANA. T. Newell
A. T. Newell
JLJ. V. Logan
J. V. Logan
RCR. A. Carrasco
R. A. Carrasco
ZAZ. M. Alsaad
Z. M. Alsaad
CHC. P. Hains
C. P. Hains
PWPreston T. Webster
Preston T. Webster
The effect of majority carrier concentration and minority carrier lifetime on the performance of mid-wave infrared ( λ cutoff = 5.5 μ m ) nBn detectors with variably doped InGaAs/InAsSb type-II superlattice absorbers is investigated. The detector layer structures are grown by molecular beam epitaxy such that their absorbing layers are either undoped, uniformly doped with a target density of 4 × 1015 cm−3, or doped with a graded profile, and variable-area mesa detector arrays are fabricated. Each material's temperature-dependent minority carrier lifetime is determined by time-resolved photoluminescence, and majority carrier concentration is extracted from capacitance–voltage measurements. Detector performance is evaluated with dark current and photocurrent measurements, from which quantum efficiency and shot-noise-limited noise-equivalent irradiance are calculated. The two doped detectors have lower dark current densities compared to their undoped counterpart due to the reduction in diffusion current as well as suppression of depletion current. Although both intentionally doped devices exhibit lower minority carrier lifetimes relative to the undoped device, the device with graded doping maintains a comparable quantum efficiency to the undoped device. Ultimately, the graded doping structure exhibits the highest sensitivity with a shot noise-limited noise-equivalent irradiance of 6.3 × 1010 photons/cm2 s in low-background light conditions, within a factor of 4× of an infrared detector pixel with Rule 07 dark current density and unity quantum efficiency. A detailed analysis of the dark current, quantum efficiency, and minority carrier lifetime provides insight into the material and device design factors that must be considered to realize a device with optimal sensitivity.

4 January 2019 in IEEE Photonics Journal
Verified
Journal Article
Open access
JDJoshua Duran
Joshua Duran
ASAndrew Sarangan
Andrew Sarangan
In this paper we show that the internal quantum efficiency of NiSi Schottky-barrier photodetectors can be significantly improved as the silicide film thickness is reduced close to its percolation threshold. We fabricated photodetectors in two optical configurations (front-side and back-side illuminated) at four different film thicknesses between 1-4 nm as well as a thick (100 nm) reference device. We simultaneously fit the reflection and transmission data for each silicide film on silicon as well as for front and backside illuminations to extract the refractive index dispersion of each film. Using this technique, we can accurately determine the absorption of each constituent layer and extract the wavelength-dependent internal quantum efficiency from the external quantum efficiency. We show that the internal quantum efficiency is highly dependent on the silicide film thickness while the dark current is not. The internal quantum efficiency of our thinnest detector is the highest reported of any silicide Schottky-barrier photodetector of comparable barrier height to date with a 57× improvement over the thick (reference) device. Using an approximation to Vickers' model, we were able to fit the IQE spectra to extract the hot carrier mean-free path of electrons in NiSi.

9 October 2023 in Journal of Applied Physics
Verified
Journal Article
Open access
PDF file
ANA. T. Newell
A. T. Newell
JLJ. V. Logan
J. V. Logan
RCR. A. Carrasco
R. A. Carrasco
CHC. P. Hains
C. P. Hains
GAG. Ariyawansa
G. Ariyawansa
PWPreston T. Webster
Preston T. Webster
An investigation into the effects of 63 MeV proton irradiation on high-sensitivity mid-wave infrared InGaAs/InAsSb nBn devices is performed. Three different structures with various absorber region doping profiles are irradiated and characterized to assess their impact on performance degradation. Minority carrier lifetime is measured using time-resolved photoluminescence and lifetime damage factors are assessed. The majority carrier concentration is determined via capacitance–voltage measurements and dopant introduction rates are calculated. An analysis of dark current density is performed using these material parameters, revealing a reduction in mobility with proton fluence and the emergence of a proton-induced trap energy level. Quantum efficiency is calculated at each proton fluence, and quantum efficiency damage factors show that the graded doping structure exhibits the least reduction of quantum efficiency with dose, attributed to its effective mobility enhancement. Conclusively, detector sensitivity, assessed via shot-noise limited noise-equivalent irradiance, shows that the graded doping structure is the least susceptible to high energy proton irradiation-induced performance degradation.

9 March 2023 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
RCRigo A. Carrasco
Rigo A. Carrasco
ANAlexander T. Newell
Alexander T. Newell
ZAZinah M. Alsaad
Zinah M. Alsaad
JLJulie V. Logan
Julie V. Logan
JDJoshua M. Duran
Joshua M. Duran
PWPreston T. Webster
Preston T. Webster
Capacitance–voltage measurements are a powerful technique to determine doping profiles of semiconductor pn junctions and Schottky barrier diodes. The measurements were recently extended to III-V-based mid-wavelength nBn infrared detectors, and absorber doping densities have been extracted using the widely accepted Schottky approximation, where the potential drop across the device is assumed to be across the depleting absorber layer. However, this approach is limited to when the absorber region of the nBn is under high reverse bias and thus is only able to extract the absorber region doping profile. Here, we introduce a semi-analytical model that is capable of extracting barrier dopant polarity, doping concentration, and thickness, as well as contact and absorber layer doping concentrations, all from a capacitance–voltage measurement. Rather than solely considering the potential drop across the depleting layers, it considers the potential drop across the accumulating layer as well. This negative charge accumulation occurs for the contact and absorber layers in the case of reverse and forward biases, respectively. This allows for a single model to be applied to a capacitance–voltage curve at forward and reverse biases and it can provide regions of bias where the absorber transitions from depletion to accumulation. We compare the agreement of the semianalytical model with modeling results from commercially available finite element method software and experimental capacitance–voltage data. Finally, we show that the method is consistent with the Schottky approximation of extracting absorber doping densities at high reverse bias and discuss the model's limitations.