In this article, a new simple buck converter with zero voltage switching (ZVS) performance and almost zero output current ripple is proposed. The proposed structure's auxiliary circuit contains a capacitor and an inductor without any switches, which makes it possible to minimize the switching losses and eliminate other additional losses. The main power diode also turns off under zero current switching condition and the reverse recovery losses of the power diode is minimized. Eliminating the switching losses and the reverse recovery losses allows the converter to operate with high power efficiency, which makes it a good option for high power efficiency-required applications. In this article, five operational modes are explained. The design section includes the designing criteria of the components. Also, the efficiency analysis, control system for stabilizing the output voltage, and applying a variable inductor to ensure the soft-switching operation are analyzed. The comparison results are also discussed. Moreover, an experimental prototype of the proposed structure at 200 W output power and 75 kHz frequency is built to prove the above-mentioned advantages. Finally, the soft-switching waveforms are obtained for different output powers with various duty cycles and equal switching frequency to verify the ZVS performance of the converter at different loads and changes in input voltage and duty cycle.
8 May 2024 in IEEE Open Journal of the Industrial Electronics Society
This paper presents a new high step-up Quasi Z-source-based DC-DC converter with switched boost techniques and voltage multiplier cells. Compared to the conventional Z-Source-based converters, this converter, not only can achieve High voltage gain but also, has good efficiency at high output voltage and higher output power conditions. Most of the Z-source-based converters suffer from high current stress across the power MOSFETs and the operation in lower power. However, the other important advantages include very low input current ripple, low voltage and current stress across the power switches, no duty ratio limitation, and leakage current elimination by providing the common grounded feature. So, in this topology, the null of the output is connected to the negative terminal of the input DC source, directly. therefore, the leakage current can be eliminated completely. As a result, the proposed converter is suitable for renewable energy sources (RES) applications such as photovoltaic (PV) systems. The mathematical analysis, operating principle for the proposed converter, and comparison with other converters are evaluated. Finally, in order to verify the accurate performance of the proposed converter and confirm the mentioned features of the proposed converter, a 1 kW laboratory prototype is built and tested
21 February 2024 in IEEE Open Journal of Power Electronics
Switched capacitor multilevel inverter topologies are attractive among industrial power electronics researchers due to their applicability in sustainable energy systems such as renewable energy source (RES) applications. In this paper, a new switched capacitor (SC)-based grid-tied seven-level inverter is proposed for renewable energy sources (RES) applications. The proposed inverter can generate a seven-level output voltage waveform with voltage boosting ability and a gain factor of 3. Also, the proposed topology can provide the self voltage balancing for capacitors. The most important challenge of the SC-based topologies, i.e., the capacitor charging spike current, is solved by applying a soft charging circuit in the charging loop of the capacitors. The soft charging circuit consists of an inductor and a power diode in the capacitor charging path. Using a small size inductor in the soft charging circuit, the proposed inverter can limit the input current spikes. Comprehensive experiment results and comparisons are presented to verify the accurate performance of the proposed inverter.