We describe a technique to extract room temperature parameters of Schottky diodes based on single or double-terminal configurations whose barrier height is bias dependent. This method allows us to extract the zero bias barrier height without specific knowledge of interface states or the existence of insulator layers at the metal-semiconductor boundaries. This technique enables us to establish the type of thermionic emission mechanism, limited by a bias dependent image force potential and/or diffusion, taking into account interfacial states or layers. This technique makes use of experimental current-voltage (I-V) characteristics measured at both bias polarities and different intensities of illumination and the corresponding voltage-dependent differential slope-voltage characteristics . This method is verified experimentally on a conventional p-Silicon based Schottky diode and on metal-semiconductor and metal-insulator-semiconductor diodes fabricated on n-silicon-on-insulator substrates. Pd/Au Schottky electrodes were used, while the insulator stack of the metal-insulator-semiconductor diodes comprises an HfO2 layer on top of an SiO2 layer.
A high sensitivity photo-detector operating in the 245 to 880 nm wavelength range is reported. It is based on a planar Metal-Oxide-Semiconductor (MOS) structure fabricated on an insulator on silicon substrate where the insulator layer comprises a double layer dielectric stack of SiO2-HfO2. The MOS detector undergoes a voltage stress process after which it exhibits a record high responsivity of 0.4 A/W at 500–600 nm and 0.1 A/W at the spectrum edges, 245 and 880 nm. The structure is significantly simpler to fabricate than P-N or P-I-N junction devices and offers a lower dark current than Metal-Semiconductor-Metal diodes. Oxygen vacancies induced in the HfO2 sub-layer by the voltage stress form the conduction paths of the photo generated carriers. The penetration, under reverse bias conditions, of holes originating in the Si depletion layer is improved under illumination since their potential barrier is lowered. The compatibility with complimentary MOS technology processes makes this new structure attractive for many applications.
We report on a characterization of fundamental gain dynamics in recently developed InAs/InP quantum-dot semiconductor optical amplifiers. Multi-wavelength pump-probe measurements were used to determine gain recovery rates, following a powerful optical pump pulse, at various wavelengths for different bias levels and pump excitation powers. The recovery was dominated by coupling between the electronic states in the quantum-dots and the high energy carrier reservoir via capture and escape mechanisms. These processes determine also the wavelength dependencies of gain saturation depth and the asymptotic gain recovery level. Unlike quantum-dash amplifiers, these quantum-dots exhibit no instantaneous gain response, confirming their quasi zero-dimensional nature.
The impact of ground state amplification on the laser emission of In(Ga)As quantum dot excited state lasers is studied in time-resolved experiments. We find that a depopulation of the quantum dot ground state is followed by a drop in excited state lasing intensity. The magnitude of the drop is strongly dependent on the wavelength of the depletion pulse and the applied injection current. Numerical simulations based on laser rate equations reproduce the experimental results and explain the wavelength dependence by the different dynamics in lasing and non-lasing sub-ensembles within the inhomogeneously broadened quantum dots. At high injection levels, the observed response even upon perturbation of the lasing sub-ensemble is small and followed by a fast recovery, thus supporting the capacity of fast modulation in dual-state devices.
1 January 2010 in Journal of the Electrochemical Society
We present a metal-insulator-semiconductor nonvolatile memory capacitor based on two gold nanoparticle charge storage layers, two layers, and a multilayer HfNO/HfTiO stack. The device exhibits an equivalent oxide thickness of 7.3 nm, a hysteresis of 15 V at a gate voltage of to −8 V, and a storage charge density of . A leakage of at −10 V, a breakdown voltage of 13.3 V, and good retention properties with a hysteresis window of 10 V following more than 10 h of consecutive write/erase operations with a ±7 V swing were demonstrated. The capacitor characteristics are frequency-independent in the 10 kHz–1 MHz range.
We describe a new type of optically sensitive tunable capacitor with a wide band response ranging from the ultraviolet (245 nm) to the near infrared (880 nm). It is based on a planar Metal-Oxide-Semiconductor (MOS) structure fabricated on an insulator on silicon substrate where the insulator layer comprises a double layer dielectric stack of SiO2-HfO2. Two operating configurations have been examined, a single diode and a pair of back-to-back connected devices, where either one or both diodes are illuminated. The varactors exhibit, in all cases, very large sensitivities to illumination. Near zero bias, the capacitance dependence on illumination intensity is sub linear and otherwise it is nearly linear. In the back-to-back connected configuration, the reverse biased diode acts as a light tunable resistor whose value affects strongly the capacitance of the second, forward biased, diode and vice versa. The proposed device is superior to other optical varactors in its large sensitivity to illumination in a very broad wavelength range (245 nm–880 nm), the strong capacitance dependence on voltage and the superior current photo responsivity. Above and beyond that structure requires a very simple fabrication process which is CMOS compatible.