17 September 2007 in IEEE Transactions on Neural Systems and Rehabilitation Engineering
The gravity balancing exoskeleton, designed at University of Delaware, Newark, consists of rigid links, joints and springs, which are adjustable to the geometry and inertia of the leg of a human subject wearing it. This passive exoskeleton does not use any motors but is designed to unload the human leg joints from the gravity load over its range-of-motion. The underlying principle of gravity balancing is to make the potential energy of the combined leg-machine system invariant with configuration of the leg. Additionally, parameters of the exoskeleton can be changed to achieve a prescribed level of gravity assistance, from 0% to 100%. The goal of the results reported in this paper is to provide preliminary quantitative assessment of the changes in kinematics and kinetics of the walking gait when a human subject wears such an exoskeleton. The data on kinematics and kinetics were collected on four healthy and three stroke patients who wore this exoskeleton. These data were computed from the joint encoders and interface torque sensors mounted on the exoskeleton. This exoskeleton was also recently used for a six-week training of a chronic stroke patient, where the gravity assistance was progressively reduced from 100% to 0%. The results show a significant improvement in gait of the stroke patient in terms of range-of-motion of the hip and knee, weight bearing on the hemiparetic leg, and speed of walking. Currently, training studies are underway to assess the long-term effects of such a device on gait rehabilitation of hemiparetic stroke patients.
7 December 2010 in The International Journal of Robotics Research
Slip between the ground and wheel often cannot be avoided in most applications of mobile robots. However, a majority of controllers developed so far make a no-slip assumption with non-holonomic constraints. To achieve desired performance in the presence of slip, controllers that are robust to slip are required. In this paper, we discuss robust trajectory-tracking control for a differentially driven two-wheeled mobile robot. The structure of a differential flatness controller, which has shown distinctive advantages providing an integrated framework for planning and control, is extended to account for slip disturbances. It is shown that the differential flatness framework can be extended to develop a robust controller based on a dynamic as well as a kinematic model with slip. Simulation results for both kinematic and dynamic controllers are presented to demonstrate the effectiveness of the robust controllers. Experiments with the kinematic controller which is suited to typical laboratory and field mobile robots were conducted to validate the proposed robust controller. The simulation and experimental results show that the proposed robust controllers are effective in the presence of slip.
10 March 2011 in Journal of Mechanisms and Robotics
Several systematic approaches have been developed for the optimal design of cable-based systems. Global indices are usually employed to quantify the effectiveness of a specific design inside a reference region of the workspace. The performances at the moving platform are strictly related to cable configuration, which, in turn, depends on the pose of the moving platform. As a result, traditional designs are characterized by the high variability of performances within the workspace and are often badly tailored to the design goals. The motivation behind this paper is to formalize a new design methodology for cable-driven devices. Based on a total or partial decoupling between cable disposition and end-effector pose, this methodology allows us to achieve well-tailored design solutions for a given design requirement. The resulting systems are here defined as adaptive cable-driven systems. Two simple design problems are presented and solved with both the traditional and the novel approaches, and the advantages of the latter are emphasized by comparing the resulting design solutions.
1 July 2007 in American Control Conference (ACC)
This paper addresses the issue of flight control of high frequency time-varying dynamics of biologically motivated flapping-wing micro air vehicle (FWMAV). A control scheme based on time-averaging theory is presented for the control of longitudinal dynamics of FWMAV. The time averaging results in a simplified model which approximates the high frequency time varying dynamics of the original system. A differential flatness based non-linear controller is designed for the time-averaged system and successfully applied to the time-varying system for trajectory tracking.