ZnO particles were synthetized by the sol–gel method and subsequent heat treatment of 400, 500 and 600 °C was applied. The nano ZnO particles were incorporated to the unsaturated polyester resin by solution blending at 0.05 wt % concentration. X-ray diffraction detected the formation of a wurtzite-like structure. Viscoelastic behavior of neat polyester and nanocomposites revealed the nano ZnO particles does not promote better mechanical properties because of a weak interaction and the glass transition temperature of the polyester was favored by the presence of a higher quantity of nano-size ZnO particles. Thermogravimetric analysis at 5, 10 and 20 °C/min allowed determining the degradation kinetic parameters based on the Friedman and Kissinger models for neat polyester and nanocomposites. Heating rates promoted an increase in the temperature degradation and the addition of ZnO particles promoted a catalyst effect that reduce the amount of thermal energy needed to start the thermal degradation.
This work describes the technological and scientific efforts on designing, manufacturing and testing validation for high performance-low cost composite structures for Light Sport Aircrafts (LSA). A Mexican initiative to conceive, manufacture and assembly a Light Sport Aircraft has been developed by using Computational Fluid Dynamics (CFD), Finite Element Analysis (FEA) and Liquid Composite Manufacturing (LCM). These consolidated techniques are used to characterize novel approaches to manufacturing and assembly carbon-fiber based structural components. As large structures are manufactured via Vacuum Assisted Resin Infusion (VARI), impregnation strategies are studied to minimize inner flaws and also to improve the manufacturing time and surface quality of each component. The first case of study, to validate this methodology, involves non-structural components such as the cowling. Control surfaces (ailerons, rudder, elevator and flaps) have been manufactured, each of them having common issues but also unique challenges. As an example, a second case of study, the aileron main beam is analyzed. Furthermore, test portfolio will be developed with the goal to perform 1-to-1 scale mechanical tests for validation in compliance with ASTM standards.
1 April 2015 in Journal of Petroleum Science and Engineering
This paper presents the development of an hybrid Unmanned Aerial Vehicle that combines the capabilities of Vertical Takeoff and Landing (VTOL) as well as the hover flight of an helicopter, with the autonomy, load capacity and speed offered by an airplane. We start from an aircraft concept that uses the Tilt-Rotor configuration to perform the transition phase from one flight mode to another and simultaneously we used Ducted-Fans for increasing the flight performance during the vertical flight phase. The aerodynamic design is developed using computational tools, such as XFLR5 for preliminary design and ANSYS FLuent®for the verification of the preliminary fixed wing design. While for the vertical flight, experimental tests were conducted in order to determine the lift system requirements by using Ducted-Fans. Afterwards, the manufacturing process derived from the aerodynamic design is presented. The avionics developed is described for handling the control surfaces during the airplane mode and the main lift system during the vertical flight as well as the integration of mechanism and sensors used. Finally, the obtained results from the conducted vertical flight tests at outdoors environments are presented in order to show the effectiveness of the aircraft concept.