Elvis Covilla

Mr. Elvis Covilla

Charles University, Prague, Praha, Hlavní Město, Czech Republic
orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 October 2022 in Polymers
Verified
Journal Article
Open access
PDF file
ETEmilio Turbay
Emilio Turbay
GMGilberto Martinez-Arguelles
Gilberto Martinez-Arguelles
TNTatiana Navarro-Donado
Tatiana Navarro-Donado
ESEdgar Sánchez-Cotte
Edgar Sánchez-Cotte
Rodrigo Polo-MendozaRodrigo Polo-Mendoza
Rodrigo Polo-Mendoza
ECElvis Covilla
Elvis Covilla
Crumb rubber (CR) is one of the materials most widely used in the road infrastructure industry due to its mechanical and environmental benefits as an asphalt binder modifier. Nonetheless, CR decreases the workability of mixes by increasing the viscosity of the binder, leading to an increase in the production temperatures of asphalt mixes. However, warm mix technologies can reduce the temperature demand associated with these processes. The preceding explains the growing interest in producing rubberised asphalt binders incorporating warm mix asphalt (WMA) additives. In this research, the mechanical and rheological properties of a 60/70 penetration grade asphalt binder modified with CR (at a dosage of 15, 18 and 21% by the wet process) and WMA chemical additives (Evotherm M1 and Iterlow T) were investigated. Laboratory tests included penetration, softening point, rotational viscosity, frequency sweep through dynamic shear rheometer (DSR), and multiple stress creep recovery (MSCR) tests. The results indicate that CR increases the stiffness of the asphalt binder, which is reflected in a lower penetration grade and improved softening point. It also improves its rutting resistance but decreases fatigue performance. Furthermore, it has been shown that under the conditions studied, the higher the CR content, the more elevated the degree of stiffness and performance of the asphalt binder. On the other hand, WMA technology decreases asphalt stiffness and performance at high temperatures.

1 January 2025 in Canadian Geotechnical Journal
Verified
Journal Article
Closed access
ECElvis Covilla
Elvis Covilla
DMD. Mašín
D. Mašín
JDJose Duque
Jose Duque
JNJ. Najser
J. Najser
JRJ. Roháč
J. Roháč
This article experimentally evaluates the influence of the sample preparation method on the undrained monotonic and cyclic response of a saturated Malaysian kaolin. Two different sample preparation methods were adopted: slurry consolidation and moist compaction. The results of undrained monotonic triaxial tests showed the same critical state friction angle regardless of the sample preparation method and overconsolidation ratio. Under undrained cyclic loading, the well-known reduction in the number of cycles required to reach failure conditions with increasing cyclic stress ratios was evident regardless of the sample preparation method. However, important qualitative differences were observed depending on the sample preparation method, such as the degree of inherent anisotropy manifested in terms of the inclination of the effective stress paths, and the asymmetric vertical strain accumulation in the stress–strain space. The reasons for the observed differences in behavior are analyzed and discussed in the manuscript.

10 September 2026 in Sci
Verified
Journal Article
Open access
PDF file
JFJosé Eduardo Salcedo Fontalvo
José Eduardo Salcedo Fontalvo
AGAngie Murillo Galindo
Angie Murillo Galindo
DADaniela Lucia Vega Araujo
Daniela Lucia Vega Araujo
Ibrahim Khalil Dawd BermejoIbrahim Khalil Dawd Bermejo
Ibrahim Khalil Dawd Bermejo
Rodrigo Polo-MendozaRodrigo Polo-Mendoza
Rodrigo Polo-Mendoza
ECElvis Covilla
Elvis Covilla
This study evaluates four granular sub-bases for pavement applications under Colombian conditions. A natural granular sub-base with a nominal maximum aggregate size of approximately 38 mm (i.e., GSB38) served as the control. Three modified mixtures comprised (i) 90% GSB38 with 5% Recycled Concrete Aggregate (RCA) and 5% Crumb Rubber (CR), (ii) 80% GSB38 with 10% RCA and 10% CR, and (iii) 70% GSB38 with 15% RCA and 15% CR. Thus, these formulations represented total recycled contents of 10%, 20%, and 30%, respectively, calculated on a dry-mass basis. Particle size distribution, standard Proctor compaction, Los Angeles abrasion, and four-day soaked California Bearing Ratio (CBR) tests were performed, and results were evaluated against Colombian specifications. An attributional cradle-to-gate Life-Cycle Assessment (LCA) with a one-tonne functional unit used SimaPro 9.4, Ecoinvent 3.9, and TRACI 2.1. All formulations complied with gradation, compaction, and abrasion requirements. As recycled content increased, optimum moisture content rose from 7.695% to 9.001%, maximum dry density fell from 2.388 to 2.072 g/cm3, and abrasion loss rose from 42.0% to 45.5%. Design CBR responded nonmonotonically, with design CBR values of 44.4%, 24.9%, 59.3%, and 90.1% for formulations with 0, 10, 20, and 30% total recycled material content, respectively. The 10% formulation failed the minimum CBR criterion, whereas the other mixtures met the high-traffic requirement. All recycled formulations reduced all considered environmental indicators; for example, the 30% recycled-content mixture decreased ozone depletion by 20.199% and global warming potential by 3.501%. Overall, the sub-base formulations with 20% and 30% of total recycled content showed strong technical and environmental potential, although replicated testing and field validation remain necessary.