In this study, the axial fatigue behaviour of hot forging tool steels at room temperature was investigated. Fatigue tests were performed on two steels within the same H13 specification. The fatigue tests were carried out in the high-cycle fatigue domain under normal conditions. These tests were also performed on specimens in contact with a corrosive medium, applying stress values that led to the high-cycle fatigue domain under normal conditions for the sake of comparison. Both materials showed similar fatigue strengths when they were tested under normal conditions. In contrast, corrosion fatigue lives were much lower than in normal tests and differed significantly between the two steels. Crack initiation was triggered by microstructural and surface defects in the normal tests, whereas the formation of corrosion pits caused crack initiation in the corrosion fatigue tests. Moreover, a fracture surface analysis revealed dissimilar crack propagation areas between both steels, which suggested that both steels had different fracture toughness. These results were in line with the differences observed between the carbide and grain sizes of both of the material microstructures.
Shot peening is generally used to improve the fatigue performance of mechanical components. However, identifying the geometrical and mechanical characteristics of the shots that improve fatigue strength is still a challenging task, as there are many variables involved in the shot peening process. The present work addresses the effect of different shot media on the fatigue behaviour of an aluminium alloy 6082 T6. Four different shot types were used: silica microspheres, alumina shots, aluminium cut wire and zinc cut wire. Axial fatigue tests were carried out to obtain the Wöhler curves corresponding to each shot peening treatment. The surface properties of the shot-peened specimens, such as grain size, hardness, residual stress and roughness were measured to determine their effect on the fatigue results. The fatigue results revealed that silica and zinc shots increased significantly the fatigue life of the alloy, whereas alumina and aluminium shots reduced its fatigue strength. Almen intensities have shown to correlate well with grain refinement and strain hardening. However, better fatigue results were obtained with the shots that generated higher surface compressive residual stresses. It is believed that small and smooth shots are preferable to sharp and irregular ones, regardless of the Almen intensity or surface hardness attained with the latter.
Laser-based manufacturing technologies have consolidated their key position among competitor manufacturing technologies thanks to the elevated level of accuracy, productivity, consistency, and flexibility provided by the advances in laser technology (e
This study explores the potential of laser surface modification (LSM) to enhance the biological properties of melt-derived bioactive glasses, specifically 45S5 and ICIE16, which are key in medical implants due to their bone-regenerating capabilities. Despite their bioactivity, these materials have limitations in cellular adhesion due to their smooth surfaces. LSM enables the creation of precise surface patterns that could improve interactions with biological environments. This study involved surface texturing bioactive glass (BG) samples using CO2 and femtosecond (fs) laser systems, modifying the laser average power, scanning speed, line spacing, and number of passes. Characterization methods included optical and stereoscopic microscopy, profilometry, and solubility tests in Tris-HCl buffer to evaluate surface roughness evolution, morphology, and bioactive behavior. The findings demonstrated significant modifications in surface properties post-texturing. The CO2 laser-treated surfaces preserve the increased roughness values after 75 days of immersion in Tris-HCl buffer for both 45S5 and ICIE16 melt-quenched bioactive glasses, showing a potential long-term osteoconductivity enhancement. On the contrary, the femtosecond laser-treated surfaces revealed a preferential apatite precipitation ability at the pattern grooves. Femtosecond laser modification stands as a suitable technique to provide preferential osteoconductivity characteristics when conducted on the surface of bioactive glass with moderate reactivity, such as ICIE16 bioactive glass.