This study aims at showing the potential of additive manufacturing as a new processing route for designing future insulators in the building sector. Polycarbonate (PC) is studied as a possible candidate for designing these new insulators. This polymer offers several advantages, among them fire resistance and stability of its physical properties at high temperatures. The 3D printing of PC is attempted using fused deposition modelling technology. The printing temperature and infill rate are varied to achieve optimal mechanical and thermal characteristics. The results show that an optimal printing temperature of 280 °C is needed to achieve high tensile performance. In addition, thermal properties including thermal conductivity and effusivity increase with the increase of the infill rate in opposition to the thermal diffusivity decrease.
This study was aimed at considering the potential of wood-based composites processed using additive manufacturing as insulators in the building sector. A polylactic acid blend with 30% wood particles was used as a feedstock material in fused filament technology. Its thermal and mechanical properties were determined for various processing conditions, including printing temperature and infill rate. The results showed a minor contraction in its tensile performance as a result of the printing process. The printing temperature had a negligible effect on its stiffness and a limited influence on the other engineering constants, such as the tensile strength and ultimate stress. The thermal properties of printed structures have been found to significantly depend on the infill rate. Although the tested 3D printed wood-PLA material exhibited good thermal properties, which were tuneable using the printing conditions, its performance was still 38% to 57% lower compared to insulators such as the glass wool of the synthetic foams used in the building sector.
Few studies have reported the performance of Polylactic acid (PLA) flax feedstock composite for additive manufacturing. In this work, we report a set of experiments conducted by fused filament technology on PLA and PLA-flax with the aim of drawing a clear picture of the potential of PLA-flax as a feedstock material. Nozzle and bed temperatures are both combined with the printing angle to investigate their influence on structural and mechanical properties. The study shows a low sensitivity of PLA-flax to process parameters compared to PLA. A varied balance between shearing and uniaxial deformation is found consistent with tensile results where filament crossing at −45/+45° provides the optimal load-bearing capabilities. However, Scanning Electron Microscopy (SEM) and high-speed camera recording shows a limiting reinforcing effect of flax fibre due to the presence of intra-filament porosity and a significant amount of fibre pull-out resulting from the tensile loading. These results suggest that the quality of the bond between PLA matrix and flax fibre, intra-filament porosity, and surface roughness should receive more attention as well as the need for more continuous fibre reinforcement in PLA filaments to optimise the performance of PLA-flax printed materials.
This paper presents an experimental investigation of the hygrothermal and mechanical properties of innovative mortar mixtures reinforced with natural fibers. Fibers extracted from palm stems (PS) and hemp (HF) were evaluated at different percentages. Scanning electron microscope (SEM) observations showed that the PS fibers have rough surfaces and very complex microstructures. Prior to their incorporation into the mortar, the fibers were subjected to different treatments to reduce their hydrophilic character. The employed treatments showed good efficiency in reducing the water absorption of both PS and HF fiber types. Furthermore, the mortar mixtures incorporating these fibers exhibited low thermal conductivity and excellent moisture buffering capacity. Indeed, the moisture buffer value (MBV) of the investigated mixtures ranged between 2.7 [g/(%HR·m2)] and 3.1 [g/(%HR·m2)], hence providing them excellent moisture regulator character. As expected, the fiber mortar mixtures showed very high porosity and low compressive strength ranging between 0.6 and 0.9 MPa after 28 days of age. The low-environmental footprint materials developed in this study are intended for thermal insulation and building filling.
25 November 2023 in Construction and Building Materials