The dynamics of a fluid in a vertical tube, subjected to an oscillatory pressure gradient, is studied experimentally for both a Newtonian and a viscoelastic shear-thinning fluid. Particle image velocimetry is used to determine the two-dimensional velocity fields in the vertical plane of the tube axis, in a range of driving amplitudes from and of driving frequencies from . The Newtonian fluid exhibits a laminar flow regime, independent of the axial position, in the whole range of drivings. For the complex fluid, instead, the parallel shear flow regime exhibited at low amplitudes [Torralba et al., Phys. Rev. E 72, 016308 (2005)] becomes unstable at higher drivings against the formation of symmetric vortices, equally spaced along the tube. At even higher drivings the vortex structure itself becomes unstable, and complex nonsymmetric structures develop. Given that inertial effects remain negligible even at the hardest drivings , it is the complex rheology of the fluid that is responsible for the instabilities observed. The system studied represents an interesting example of the development of shear-induced instabilities in nonlinear complex fluids in purely parallel shear flow.
1 October 2007 in Energy Conversion and Management
The use of the phase change material (PCM) as a storage medium represents an important advance to store energy for the absorption cooling systems when solar energy is not available; however, the temperature of the storage tank is a key parameter for the adequate operation of the cooling system. This paper presents a parametric analysis of a flat and a commercial plate heat exchangers with MgCl2·6H2O as the PCM at absorption cooling conditions. The plate heat exchanger (PHE) is a chevron type with an angle of 45° and a plate area of 0.04 m2. The governing equation was solved using the method of finite difference. The results showed that the corrugated plate improved the heat transfer than the flat plate; however, the flat plate obtained a higher operation time than the corrugated plate for the absorption cooling condition in the discharge process because the output temperature of the PHE was much higher than the operating conditions. Finally, the decrement of the PCM thickness and the increment of the input temperature and flowrate of the heating fluid improved the heat transfer of the PHE; however, the main thermal resistance was still in the PCM.
Electricity is fundamental to modern societies and will become even more so as its use expands through different technologies and population growth. Power generation is currently the largest source of carbon-dioxide (CO2) emissions globally, but it is also the sector that is leading the transition to net zero emissions through the rapid rise of renewables. The impacts of COVID-19 on the electricity sector led to a reduction in the demand for electricity, while at the same time, the current global energy crisis has placed the security and affordability of electricity at the top of the political agenda in many countries. In this way, the decrease in the demand for electricity, as well as its gradual recovery, makes it necessary to carry out energy planning that considers the adverse effects caused by global events with a high socioeconomic impact. In this article, the Low Emission Analysis Platform (LEAP) 2020 software has been used to determine the distribution of energy sources to 2050 for Mexico. The variables that lead to the possible profiles for 2050 are social, economic, and technological. The results correspond to a possible future based on official data from the National Electric System (SEN) of Mexico. The forecast for 2050 indicates that the electricity sector will have almost double the current installed capacity; however, emissions do not correspond to twice as much: they are practically 50% higher.
In recent years, the reports presented on climate change and its consequences highlight the need to create public policy agendas that address the problem of adaptation and mitigation of anthropogenic greenhouse gas (GHG) emissions. Globally, the energy sector is responsible for a significant percentage of GHG emissions, while it is one of the most important sector for economic growth. In particular, the electricity sector in Mexico relies heavily on fossil fuels for electricity generation. This problem has made it essential to design plans and policies that contribute to GHG mitigation. The General Law on Climate Change, whose objective is to determine the guidelines towards a low-carbon economy, has established a goal of reducing emissions by 50% by 2050 concerning the baseline from the year 2000 and proposes to produce 50% of electricity with clean energy by 2050 following the Mexican Energy Transition Law. For this reason, the challenge is to design and develop an environmentally sustainable energy model for the National Electric System (NES). Different scenarios are defined and evaluated considering six probable growing electricity demands, as well as mature technologies considering the potential of renewable resources in Mexico, fossil fuel reserves, efficiencies of each technology, investment costs, operation costs, and maintenance costs along with the price of the fuels. The results showed that it is possible to reduce about 50% of the emissions from the electricity sector by 2050 considering a scenario of low population growth and a yearly per capita consumption of 2.0 MWh, as well as a diversification of the electricity generation matrix.